Search results
Results from the WOW.Com Content Network
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6, the default route is specified by :: / 0. The subnet mask is specified as / 0, which effectively specifies all networks and is the shortest match possible. A route lookup that does not match any other ...
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
For instance, a router may have a static or connected route for a local network segment, which is then redistributed over dynamic routing protocols to enable connectivity to that network. [4] By using the metric to reduce the priority of a static route a fallback can be provided for instance when a DHCP server becomes unavailable. This can also ...
When multiple route table entries match, the entry with the longest subnet mask is chosen as it is the most specific one. [2] If there are multiple routes with the same subnet mask, the route with the lowest metric is used. If there are multiple default routes, the metric is also used to determine which to use.
These uses do not result in IPv4 packets containing 0.0.0.0 and so are not governed by RFC 1122. [2] These meanings may not be consistent between operating systems. In both Windows and Linux, when selecting which of a host's IP address to use as a source IP, a program may specify INADDR_ANY ( 0.0.0.0 ).
Replacement command Note ifconfig: ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle ...
default or static routes that are manually configured, [3] [4] on-demand routing, [5] dynamic routing protocols, [6] or; Policy-based routing. [7] In a small network such as a home or home office, a default route is often used to send all traffic to the user's Internet service provider.