enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Multi-mode optical fiber - Wikipedia

   en.wikipedia.org/wiki/Multi-mode_optical_fiber

   The equipment used for communications over multi-mode optical fiber is less expensive than that for single-mode optical fiber. [1] Typical transmission speed and distance limits are 100 Mbit/s for distances up to 2 km (), 1 Gbit/s up to 1000 m, and 10 Gbit/s up to 550 m.

3. Fiber cable termination - Wikipedia

   en.wikipedia.org/wiki/Fiber_cable_termination

   A fiber pigtail is a single, short, usually tight-buffered, optical fiber that has an optical connector pre-installed on one end and a length of exposed fiber at the other end. The end of the pigtail is stripped and fusion spliced to a single fiber of a multi-fiber trunk. Splicing of pigtails to each fiber in the trunk "breaks out" the multi ...

4. Mode scrambler - Wikipedia

   en.wikipedia.org/wiki/Mode_scrambler

   If multimode fiber bandwidth is measured using a laser diode directly coupled to its input, the resulting measurement can vary by as much as an order of magnitude. This measurement variability is due to the combination of differences in laser output characteristics (emitted mode power distribution) and the differential mode delay of the fiber.

5. Optical fiber connector - Wikipedia

   en.wikipedia.org/wiki/Optical_fiber_connector

   LC (top) and ST (bottom) optical fiber connectors, both with protective caps in place. An optical fiber connector is a device used to link optical fibers, facilitating the efficient transmission of light signals. An optical fiber connector enables quicker connection and disconnection than splicing.

6. Optical fiber - Wikipedia

   en.wikipedia.org/wiki/Optical_fiber

   Extrinsic fiber optic sensors use an optical fiber cable, normally a multi-mode one, to transmit modulated light from either a non-fiber optical sensor—or an electronic sensor connected to an optical transmitter. A major benefit of extrinsic sensors is their ability to reach otherwise inaccessible places.

7. Fiber-optic communication - Wikipedia

   en.wikipedia.org/wiki/Fiber-optic_communication

   Fiber-optic communication is a form of optical communication for transmitting information from one place to another by sending pulses of infrared or visible light through an optical fiber. [ 1 ] [ 2 ] The light is a form of carrier wave that is modulated to carry information. [ 3 ]