enow.com Web Search

  1. Ads

    related to: husqvarna 440 carburetor removal

Search results

  1. Results from the WOW.Com Content Network
  2. Component parts of internal combustion engines - Wikipedia

    en.wikipedia.org/wiki/Component_parts_of...

    Although carburetor technology in automobiles reached a very high degree of sophistication and precision, from the mid-1980s it lost out on cost and flexibility to fuel injection. Simple forms of carburetor remain in widespread use in small engines such as lawn mowers and more sophisticated forms are still used in small motorcycles.

  3. Kawasaki 440 - Wikipedia

    en.wikipedia.org/wiki/Kawasaki_440

    The single ignition system uses a coil and points. Fuel is metered by a Mikuni 34 mm slide-type carburetor. Starting is by a recoil starter system with electric start as an option. [1] In its aircraft applications the 440 uses an aftermarket reduction drive system to reduce the maximum 5000 rpm to a speed more manageable for propeller use. [1]

  4. Carburetor - Wikipedia

    en.wikipedia.org/wiki/Carburetor

    To remove the excess fuel, many carburetors with automatic chokes allow it to be held open (by manually, depressing the accelerator pedal to the floor and briefly holding it there while cranking the starter) to allow extra air into the engine until the excess fuel is cleared out.

  5. Carburetor heat - Wikipedia

    en.wikipedia.org/wiki/Carburetor_heat

    Carburetor heat uses hot air drawn from the heat exchanger or heat stove (a metal plate around the exhaust manifold) to raise the temperature in the venturi section high enough to prevent or remove any ice build-up. Because hot air is less dense than cold air, engine power will drop when carburetor heat is used.

  6. Ignition coil - Wikipedia

    en.wikipedia.org/wiki/Ignition_coil

    An ignition coil consists of an iron core surrounded by two coils (windings) made from copper wire.The primary winding has relatively few turns of heavy wire, while the secondary winding consists of thousands of turns of smaller wire and is insulated from the high voltage by enamel on the wires and layers of oiled paper insulation.

  7. Chainsaw - Wikipedia

    en.wikipedia.org/wiki/Chainsaw

    The carburetor may need to be adjusted to maintain an appropriate idle speed and air-fuel ratio, such as when moving to a higher/lower altitude or as the air filter clogs. Carburetors are adjusted either by the operator or, in some saws, automatically by an electronic control unit. [citation needed]

  8. Edelbrock - Wikipedia

    en.wikipedia.org/wiki/Edelbrock

    Edelbrock has two facilities in North Carolina: the Edelbrock Carburetor Division in Sanford, and the Edelbrock Race Center in Mooresville. Vic Edelbrock founded the corporation in 1938 when his desire to increase the performance of his 1932 Ford Roadster led him to design a new intake manifold , [ 3 ] friends and fellow drivers soon wanted one ...

  9. Reece Fish Carburettor - Wikipedia

    en.wikipedia.org/wiki/Reece_Fish_Carburettor

    The Fish carburetor was also sensitive to mass airflow, rather than volume airflow, making it self-compensating for changes due to temperature or altitude. [ 1 ] A second problem with the conventional carburetor was its good performance in steady conditions, but poor progression: its dynamic ability to respond, such as when suddenly opening the ...

  1. Ads

    related to: husqvarna 440 carburetor removal