enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Headset (bicycle part) - Wikipedia

   en.wikipedia.org/wiki/Headset_(bicycle_part)

   This bolt is connected to a star nut driven down into the steerer tube that acts as an anchor by gripping the inside of the steerer tube with a downward force. The star nut may be replaced by a self expanding wedge in some designs. The bolt compresses the stem down onto spacers, usually aluminum, which in turn compress the headset bearing cups.

3. Spacers and standoffs - Wikipedia

   en.wikipedia.org/wiki/Spacers_and_standoffs

   A standoff is a threaded separator of defined length used to raise one part in an assembly above another. They are usually round or hex (for wrench tightening), often made of stainless steel, aluminum, brass, or nylon, and come in male-female or female-female forms. In electronics they are frequently used to raise a printed-circuit board above ...

4. List of Ford bellhousing patterns - Wikipedia

   en.wikipedia.org/wiki/List_of_Ford_bellhousing...

   200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8. 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block. 302 Cleveland (Australia) 351 Cleveland V8 (not the 351 Cleveland M-block engine) 351 Boss. 351 Cobra Jet.

5. Wheel stud - Wikipedia

   en.wikipedia.org/wiki/Wheel_stud

   Wheel stud. Wheel studs are the threaded fasteners that hold on the wheels of many automobiles. They are semi-permanently mounted directly to the vehicle hub, usually through the brake drum or brake disk. Lug nuts are fastened onto the wheel stud to secure the wheel. When a wheel is removed for tire changes etc., the stud remains in the hub.

6. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   Computer case screws. From left to right: a #6-32 UNC thumbscrew, a #6-32 UNC screw, an M3 screw and a self-tapping screw for case fans. Computer case screws are the hardware used to secure parts of a PC to the case. Although there are numerous manufacturers of computer cases, they have generally used three thread sizes.

7. Continuous casting - Wikipedia

   en.wikipedia.org/wiki/Continuous_casting

   Continuous casting, also called strand casting, is the process whereby molten metal is solidified into a "semifinished" billet, bloom, or slab for subsequent rolling in the finishing mills. Prior to the introduction of continuous casting in the 1950s, steel was poured into stationary molds to form ingots. Since then, "continuous casting" has ...