Ad
related to: scale factor in autocad chartAutodesk.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
Newmark's influence chart. Newmark's Influence Chart is an illustration used to determine the vertical pressure at any point below a uniformly loaded flexible area of soil of any shape. This method, like others, was derived by integration of Boussinesq's equation for a point load. [1]
Geodesy. The Universal Transverse Mercator (UTM) is a map projection system for assigning coordinates to locations on the surface of the Earth. Like the traditional method of latitude and longitude, it is a horizontal position representation, which means it ignores altitude and treats the earth surface as a perfect ellipsoid.
v. t. e. An engineering drawing is a type of technical drawing that is used to convey information about an object. A common use is to specify the geometry necessary for the construction of a component and is called a detail drawing. Usually, a number of drawings are necessary to completely specify even a simple component.
The vertical exaggeration is given by: = where VS is the vertical scale and HS is the horizontal scale, both given as representative fractions.. For example, if 1 centimetre (0.39 in) vertically represents 200 metres (660 ft) and 1 centimetre (0.39 in) horizontally represents 4,000 metres (13,000 ft), the vertical exaggeration, 20×, is given by:
In affine geometry, uniform scaling (or isotropic scaling[1]) is a linear transformation that enlarges (increases) or shrinks (diminishes) objects by a scale factor that is the same in all directions (isotropically). The result of uniform scaling is similar (in the geometric sense) to the original. A scale factor of 1 is normally allowed, so ...
This implies that the vertical scale factor, h, equals the horizontal scale factor, k. Since k = sec φ, so must h. The graph shows the variation of this scale factor with latitude. Some numerical values are listed below. at latitude 30° the scale factor is k = sec 30° = 1.15, at latitude 45° the scale factor is k = sec 45° = 1.41,
A contour chart of scale factors of GS50 projection Maps reflecting directions, such as a nautical chart or an aeronautical chart , are projected by conformal projections. Maps treating values whose gradients are important, such as a weather map with atmospheric pressure , are also projected by conformal projections.
The scale of a map is the ratio of a distance on the map to the corresponding distance on the ground. This simple concept is complicated by the curvature of the Earth 's surface, which forces scale to vary across a map. Because of this variation, the concept of scale becomes meaningful in two distinct ways.
Ad
related to: scale factor in autocad chartAutodesk.com has been visited by 100K+ users in the past month