Search results
Results from the WOW.Com Content Network
When oil is produced to surface temperature and pressure it is usual for some natural gas to come out of solution. The gas/oil ratio (GOR) is the ratio of the volume of gas ("scf") that comes out of solution to the volume of oil — at standard conditions. In reservoir simulation gas/oil ratio is usually abbreviated .
The issue is still subject of numerous studies, and prompting academic argument. That's mainly because the "energy invested" critically depends on technology, methodology, and system boundary assumptions, resulting in a range from a maximum of 2000 kWh/m 2 of module area down to a minimum of 300 kWh/m 2 with a median value of 585 kWh/m 2 according to a meta-study from 2013.
The steam to oil ratio is a measure of the water and energy consumption related to oil production in cyclic steam stimulation and steam assisted gravity drainage oil production. SOR is the ratio of unit of steam required to produce unit of Oil. The typical values are three to eight and two to five respectively. This means two to eight barrels ...
The reserves-to-production ratio is the most widely quoted of the key indicators used in the oil and gas industry. It has a certain strategic significance for companies, which try to keep the value reasonably constant at approximately 10 years. A ratio which falls too low indicates a company in poor health.
The materials balance method for an oil or gas field uses an equation that relates the volume of oil, water and gas that has been produced from a reservoir and the change in reservoir pressure to calculate the remaining oil & gas. It assumes that, as fluids from the reservoir are produced, there will be a change in the reservoir pressure that ...
The higher the mpg, the more fuel-efficient your car is and the less money you’ll spend on gas during your road trip. Now, to calculate gas cost per mile simply divide the total miles driven by ...
How to calculate the current ratio. You can calculate the current ratio by dividing a company’s total current assets by its total current liabilities. Again, current assets are resources that ...
The ratios were obtained using the criterion that choked flow occurs when the ratio of the absolute upstream pressure to the absolute downstream pressure is equal to or greater than ([+] /) / (), where is the specific heat ratio of the gas. The minimum pressure ratio may be understood as the ratio between the upstream pressure and the pressure ...