Search results
Results from the WOW.Com Content Network
Reduced media-independent interface (RMII) is a standard which was developed to reduce the number of signals required to connect a PHY to a MAC. Reducing pin count reduces cost and complexity for network hardware especially in the context of microcontrollers with built-in MAC, FPGAs, multiport switches or repeaters, and PC motherboard chipsets ...
In computer networking, a media access control attack or MAC flooding is a technique employed to compromise the security of network switches.The attack works by forcing legitimate MAC table contents out of the switch and forcing a unicast flooding behavior potentially sending sensitive information to portions of the network where it is not normally intended to go.
MAC addresses are formed according to the principles of two numbering spaces based on extended unique identifiers (EUIs) managed by the Institute of Electrical and Electronics Engineers (IEEE): EUI-48—which replaces the obsolete term MAC-48—and EUI-64. Network nodes with multiple network interfaces, such as routers and multilayer switches ...
IEEE 802.1aq is an amendment to the IEEE 802.1Q networking standard which adds support for Shortest Path Bridging (SPB).This technology is intended to simplify the creation and configuration of Ethernet networks while enabling multipath routing.
The original 2.94 Mbit/s Ethernet implementation had eight-bit addresses and other differences in frame format. [9] 10BASE5: 802.3-1985 (8) AUI, N, vampire tap: 500 m RG-8/U Original standard uses a single coaxial cable in which a connection is made by tapping into the single cable, drilling in to make contact with the core and the screen.
In such equipment, bufferbloat occurs when a network link becomes congested, causing packets to become queued for long periods in these oversized buffers. In a first-in first-out queuing system, overly large buffers result in longer queues and higher latency, and do not improve network throughput. It can also be induced by specific slow-speed ...
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport
An Ethernet frame including the EtherType field. Each lower slot designates an octet; the EtherType is two octets long. In modern implementations of Ethernet, the field within the Ethernet frame used to describe the EtherType can also be used to represent the size of the payload of the Ethernet Frame.