enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Nail gun - Wikipedia

   en.wikipedia.org/wiki/Nail_gun

   Nail guns vary in the length and gauge (thickness) of nails they can drive. Air compressor supplies air into a nail gun. The smallest size of fasteners are normally 23 gauge (0.025 inches or 0.64 millimetres in diameter), commonly called "pin nailers" and generally have only a minimal head.

3. Penny (unit) - Wikipedia

   en.wikipedia.org/wiki/Penny_(unit)

   A larger number indicates a longer nail, shown in the table below. Diameter of the nail also varies based on penny size, depending on nail type. Nails under 1 + 1 ⁄ 4 inch, often called brads, are sold mostly in small packages with only a length designation or with length and wire gauge designations; for example, 1″ 18 ga. or 3 ⁄ 4 ″ 16 ga.

4. Powder-actuated tool - Wikipedia

   en.wikipedia.org/wiki/Powder-actuated_tool

   The colored straws in the tray contain cartridges that are loaded singly into the tool. Also visible are 75 mm hardened steel nails with 8 mm heads. Powder actuated tools can be variously classified: Direct acting (the charge acts directly on the head of the nail or high velocity), or indirect (using an intermediate piston or low velocity)

5. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   A 50 × 3.0 indicates a nail 50 mm long (not including the head) and 3 mm in diameter. Lengths are rounded to the nearest millimetre. Lengths are rounded to the nearest millimetre. For example, finishing nail* sizes typically available from German suppliers are:

6. Paslode - Wikipedia

   en.wikipedia.org/wiki/Paslode

   Paslode is a tool manufacturer. Paslode is an acronym for PA cking S hipping LO ading DE vices and was founded in 1935. The company develops and manufactures nail and staple guns; either powered by proprietary butane cylinders (in combination with battery power) or an external supply of pressurized air.

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The term fine adjustment screw typically refers to screws with threads from 40–100 TPI (Threads Per Inch) (0.5 mm to 0.2 mm pitch) and ultra fine adjustment screw has been used to refer to 100–254 TPI (0.2 mm to 0.1 mm pitch). These screws are most frequently used in applications where the screw is used to control fine motion of an object.