enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Antenna amplifier - Wikipedia

   en.wikipedia.org/wiki/Antenna_amplifier

   In electronics, an antenna amplifier (also: aerial amplifier or booster) is a device that amplifies an antenna signal, usually into an output with the same impedance as the input impedance. Typically 75 ohm for coaxial cable and 300 ohm for twin-lead cable. An antenna amplifier boosts a radio signal considerably for devices that receive radio ...

3. The 7 Best HDTV Antenna Amplifiers of 2023 For a Better Signal

   www.aol.com/lifestyle/best-high-definition-tv...

   8-Port TV Distribution Amplifier. For households with multiple TVs, the Antennas Direct 8-Port TV Distribution Amplifier can split a signal with no noticeable impact on signal quality.

4. Cantenna - Wikipedia

   en.wikipedia.org/wiki/Cantenna

   The 5.5 GHz cantenna dimensions are almost perfect in that they make a good fit for the standard TV satellite dish. The resulting setup is a low-cost high-quality high-gain antenna. [6] Such setups are widely used in wireless community networks for long-distance Wi-Fi links. Cantennas may be used with other RF devices such as wireless security ...

5. Tower Mounted Amplifier - Wikipedia

   en.wikipedia.org/wiki/Tower_Mounted_Amplifier

   A Tower Mounted Amplifier (TMA), or Mast Head Amplifier (MHA), is a low-noise amplifier (LNA) mounted as close as practical to the antenna in mobile masts or base transceiver stations. A TMA reduces the base transceiver station noise figure (NF) and therefore improves its overall sensitivity ; in other words the mobile mast is able to receive ...

6. Television antenna - Wikipedia

   en.wikipedia.org/wiki/Television_antenna

   Combined with a signal increase of 14 dB due to height and 11 dB due to lack of attenuating building walls, an outdoor antenna can result in a signal strength increase of up to 40 dB at the TV receiver. [6] Outdoor antenna designs are often based on the Yagi–Uda antenna [16] or log-periodic dipole array (LPDA). [17]

7. Low-noise block downconverter - Wikipedia

   en.wikipedia.org/wiki/Low-noise_block_downconverter

   The microwave signal from the dish is picked up by a feedhorn on the LNB and is fed to a section of waveguide. One or more metal pins, or probes, protrude into the waveguide at right angles to the axis and act as antennas, feeding the signal to a printed circuit board inside the LNB's shielded box for processing. The lower frequency IF output ...