enow.com Web Search

  1. Ads

    related to: anchor flange dimensions

Search results

  1. Results from the WOW.Com Content Network
  2. Anchor bolt - Wikipedia

    en.wikipedia.org/wiki/Anchor_bolt

    A cast-in-place anchor bolt. The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]

  3. ASTM A325 - Wikipedia

    en.wikipedia.org/wiki/ASTM_A325

    ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength.

  4. Offshore embedded anchors - Wikipedia

    en.wikipedia.org/wiki/Offshore_embedded_anchors

    A deep-penetrating anchor (DPA) is conceptually similar to a torpedo anchor: it features a dart-shaped, thick-walled, steel cylinder with flukes attached to the upper section of the anchor. A full-scale DPA is approximately 15 metres (49 ft) in length, 1.2 metres (4 ft) in diameter, and weighs on the order of 50–100 tonnes (49–98 long tons ...

  5. B16 Standardization of Valves, Flanges, Fittings, and Gaskets

    en.wikipedia.org/wiki/B16_Standardization_of...

    The ASME B16 Standardization of Valves Flanges, Fittings and Gaskets Committee, which operates under ASME’s Board on Pressure Technology Codes and Standards is responsible for standards covering valves, flanges, pipe fittings, gaskets and valve actuators for use in pressure services.

  6. Width across flats - Wikipedia

    en.wikipedia.org/wiki/Width_across_flats

    The size is imprinted on the spanners in millimeter values or inch sizes with intermediate sizes in fractions (older British and current US spanners). The two systems are in general not compatible, which can result in rounding of nuts and bolts (i.e. using a 13 mm (0.51 in) spanner in place of a 1 ⁄ 2 inch (12.70 mm)).

  7. Suction caisson - Wikipedia

    en.wikipedia.org/wiki/Suction_caisson

    The dimension for the top suctions caisson is 8 m × ⌀1 m and for the bottom suctions caisson is 1 m × ⌀5 m. Suction caissons (also referred to as suction anchors , suction piles or suction buckets ) are a form of fixed platform anchor in the form of an open bottomed tube embedded in the sediment and sealed at the top while in use so that ...

  8. Waveguide flange - Wikipedia

    en.wikipedia.org/wiki/Waveguide_flange

    The MIL-spec choke flanges have a gap width of between 2% and 3% of the waveguide height (the smaller inner dimension of the guide), which for WR28 waveguide (WG22) amounts to a gap of just 3 thousandths of an inch. The choke ditch in these flanges is some 8 times wider (around 20% of the waveguide height), although the proportions vary ...

  9. Washer (hardware) - Wikipedia

    en.wikipedia.org/wiki/Washer_(hardware)

    Anchor plate or wall washer A large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement. Being visible, many anchor plates are made in a style that is decorative. [5] Torque washer

  1. Ads

    related to: anchor flange dimensions