Search results
Results from the WOW.Com Content Network
The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...
Thermosyphon circulation in a simple solar water heater (not a working model; there is no water supply to replenish the tank when the tap is used). A thermosiphon (or thermosyphon) is a device that employs a method of passive heat exchange based on natural convection, which circulates a fluid without the necessity of a mechanical pump.
A forced circulation boiler is a boiler where a pump is used to circulate water inside the boiler. This differs from a natural circulation boiler which relies on current density to circulate water inside the boiler. In some forced circulation boilers, the water is circulated at twenty times the rate of evaporation. [1]
The back boiler is typically used with a gravity feed circuit to the hot water cylinder, with a vent or overflow to prevent excess pressure build up.It can also be connected to a series of radiators to provide central heating but usually requires an electrical pump to be fitted to circulate the hot water, some systems can use the gravity circuit to include radiators.
Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted natural convection and heated water to flow out of the tank. [1] [2] Newer water heaters have built-in heat traps.
A hybrid water heater is a water heating system that integrates technology traits from both the tank-type water heaters and the tankless water heaters. [5] It maintains water pressure and consistent supply of hot water across multiple hot water applications, and like its tankless cousins, it is efficient and can supply a continuous flow of hot ...
Circulating hot water can be used for central heating. Sometimes these systems are called hydronic heating systems. [22] Common components of a central heating system using water-circulation include: A supply of fuel, electric power or district heating supply lines; A boiler (or a heat exchanger for district heating) which heats water in the system
Variable speed pumps were replaced with two-speed pumps (each rated at 35,400 US gallons per minute (2.23 m 3 /s) for a discharge pressure head of 865 feet (264 m)), and a flow control valve (adjustable from 22% open to 100% open with a linear flow response) was added to each loop for use in regulating recirculation flow (capable of regulating ...