Search results
Results from the WOW.Com Content Network
The crankcase air outlet, where the PCV valve is located, is generally placed as far as possible from the crankcase breather. For example, the breather and outlet are frequently on opposite valve covers on a V engine, or on opposite ends of the valve cover on an inline engine. The PCV valve is often, but not always, placed at the valve cover ...
The vent/rollover valve provides a method of controlled escape for gasoline vapors during the refueling process. It has a mechanism which closes the vent in the event the vehicle rolls over, to prevent spilling of VOCs or fuel in general. It also acts as a fill limiter. [8] [dead link ]
The early fuel evaporator is a device found in some internal combustion engines with carburetors.It can sometimes be referred to as an electronic fuel evaporator. The device on a car, commonly referred to as an EFE heater, is located between the throttle body of the carburetor and the intake manifold as a gasket and contains a resistance grid that heats the air/fuel mixture.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission).
General Motors started with a regular-cab, short-box (6-foot (180 cm) bed) S-10 pickup, with a base-level trim package plus a half-tonneau cover. In place of a typical inline four cylinder or V-6 internal combustion engine, the Electric S-10 EV was equipped with an 85-kilowatt (114 hp) three-phase, liquid-cooled AC induction motor, based on GM's EV1 electric coupe.
1983–1990 Chevrolet S-10 Blazer 2-door 1985 Chevrolet S-10 Blazer 2-door, rear view. Base power was provided by GM's 2.0-liter OHV gasoline inline four-cylinder engine, producing up to 83 horsepower (62 kW). A 2.8-liter 110 hp (82 kW) V6 was offered as an option (coincidentally, this engine was also used in Jeep's competing Cherokee until 1987).
The Chevrolet S-10 is a compact pickup truck produced by Chevrolet.It was the first domestically-built compact pickup of the big three American automakers. When it was first introduced as a "quarter-ton pickup" in 1981 for the 1982 model year, the GMC version was known as the S-15 and later renamed the GMC Sonoma.
An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.