Ad
related to: mortise lock thumb turn knob removal service tool
Search results
Results from the WOW.Com Content Network
An officer’s tool (also known as an A-tool, rex tool, or lock puller) is a forcible entry device used by firefighters and other first responders. Officer’s tools are designed to completely remove cylindrical locks from doors without causing major structural damage, allowing for direct access to the internal locking mechanism.
The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate (or box keep), which lines and reinforces the cavity in the door jamb or frame ...
The original tool supported cutter sizes from 4 mm to 10 mm with available tenon sizes from 4x20 mm up to 10x50 mm. This allowed joints in stock as thin as 10 millimetres (0.39 in). Later a bigger tool was introduced allowing tenon sizes up to 14x140 mm, opening many carpentry use cases for the tool family.
Metal fire-resistance rated door with a lockset consisting of a locking latch bolt operated by lever handle with an escutcheon that encompasses the locking mechanism.. A lockset (alternatively lock set) is the hardware and components that make up the locking or latching mechanism that can usually be found on a door or other hinged object but can also include sliding doors and dividers. [1]
For doors, a shove knife can be wedged into the door jamb and open the latch bolt without having to deal with the lock itself. [3] Another option is to remove the cylinder lock from the door using instruments like an A-tool or K-tool; these methods also allow the door to be closed and re-locked afterward. [3]
A square, rounded or V-shaped depression, filed or machined into a key, to allow the key to turn in its lock. In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin
The first known example of a tumbler lock was found in the ruins of the Palace of Khorsabad built by king Sargon II (721–705 BC.) in Iraq. [1] Basic principles of the pin tumbler lock may date as far back as 2000 BC in Egypt; the lock consisted of a wooden post affixed to the door and a horizontal bolt that slid into the post.
The same physical principles are involved in lock bumping, but the snap gun automates the transfer-of-energy process. A correctly applied snap gun can open a lock very quickly compared to traditional lock picking, but the sharp impact is more likely to damage the lock mechanism than raking, which mimics normal key movements.
Ad
related to: mortise lock thumb turn knob removal service tool