Ad
related to: swr chart for ham radio equipment clearance requirements
Search results
Results from the WOW.Com Content Network
In radio engineering and telecommunications, standing wave ratio (SWR) is a measure of impedance matching of loads to the characteristic impedance of a transmission line or waveguide. Impedance mismatches result in standing waves along the transmission line, and SWR is defined as the ratio of the partial standing wave 's amplitude at an ...
An SWR meter for CB radio equipment. A standing wave ratio meter, SWR meter, ISWR meter (current "I" SWR), or VSWR meter (voltage SWR) measures the standing wave ratio (SWR) in a transmission line. [a] The meter indirectly measures the degree of mismatch between a transmission line and its load (usually an antenna).
FCC amateur radio station license of Al Gross. In the United States, amateur radio licensing is governed by the Federal Communications Commission (FCC). Licenses to operate amateur stations for personal use are granted to individuals of any age once they demonstrate an understanding of both pertinent FCC regulations and knowledge of radio station operation and safety considerations.
A signal strength and readability report is a standardized format for reporting the strength of the radio signal and the readability (quality) of the radiotelephone (voice) or radiotelegraph (Morse code) signal transmitted by another station as received at the reporting station's location and by their radio station equipment. These report ...
An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ-269, MFJ Enterprises Inc. An antenna analyzer or in British aerial analyser (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the input impedance of antenna systems in radio electronics applications.
Transformers, autotransformers, and baluns are sometimes incorporated into the design of narrow band antenna tuners and antenna cabling connections. They will all usually have little effect on the resonant frequency of either the antenna or the narrow band transmitter circuits, but can widen the range of impedances that the antenna tuner can match, and/or convert between balanced and ...
The directive outlines the requirements that must be met in order for Radio Equipment to meet the harmonized standard for these industry items. The list of harmonized standards is regularly published on the official journal of the European Union. Each harmonized standard covers one or more essential requirements.
Repeater frequency sets are known as "repeater pairs", and in the ham radio community most follow ad hoc standards for the difference between the two frequencies, commonly called the offset. In the USA two-meter band, the standard offset is 600 kHz (0.6 MHz), but sometimes unusual offsets, referred to as oddball splits, are used. The actual ...
Ad
related to: swr chart for ham radio equipment clearance requirements