Search results
Results from the WOW.Com Content Network
NL5 performs 3 types of AC analysis: Small signal, for linear and linearized non-linear circuits; Sweep AC source (variable-frequency sinusoidal source), for non-linear and switching circuits; z-transform, for constant frequency switching circuits
A Voltage controller thyristor based dimmer rack An electrical schematic for a typical SCR-based light dimmer. A voltage controller, also called an AC voltage controller or AC regulator is an electronic module based on either thyristors, triodes for alternating current, silicon-controlled rectifiers or insulated-gate bipolar transistors, which converts a fixed voltage, fixed frequency ...
For AC-operated devices (e.g. coaxial cable, loudspeakers), there may even be two power ratings, a maximum (peak) power rating and an average power rating. [ 5 ] [ 6 ] For such devices, the peak power rating usually specifies the low frequency or pulse energy, while the average power rating limits high-frequency operation. [ 5 ]
In an alternating current (AC) electric power system, synchronization is the process of matching the frequency, phase and voltage of a generator or other source to an electrical grid in order to transfer power. If two unconnected segments of a grid are to be connected to each other, they cannot safely exchange AC power until they are synchronized.
A small signal model consists of a small signal (having zero average value, for example a sinusoid, but any AC signal could be used) superimposed on a bias signal (or superimposed on a DC constant signal) such that the sum of the small signal plus the bias signal gives the total signal which is exactly equal to the original (large) signal to be ...
The angular frequency is related to the physical frequency, (unit: hertz), which represents the number of cycles per second, by the equation =. t {\displaystyle t} is the time (unit: second ). The peak-to-peak value of an AC voltage is defined as the difference between its positive peak and its negative peak.
A common example is to run the entire calculation suite for different input frequencies, and then plot samples on a single chart. One might use this to sample through the UHF television frequencies, for instance, producing a diagram that illustrates the gain across the band. Another common feature is an iterative solver that adjusts a given ...
In vector control, an AC induction or synchronous motor is controlled under all operating conditions like a separately excited DC motor. [21] That is, the AC motor behaves like a DC motor in which the field flux linkage and armature flux linkage created by the respective field and armature (or torque component) currents are orthogonally aligned such that, when torque is controlled, the field ...