enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. How to jump-start a car - AOL

   www.aol.com/jump-start-car-194500286.html

   5. Connect the black negative cable end to the negative (-) battery terminal in the booster car. Now that the negative cable is connected to the battery terminal, you can attach the other end to ...

3. Jump start (vehicle) - Wikipedia

   en.wikipedia.org/wiki/Jump_start_(vehicle)

   A jumper cable connected to the positive (red) terminal. Jumper cables, also known as booster cables or jump leads, are a pair of insulated wires of sufficient capacity with alligator clips at each end to interconnect the disabled vehicle with an auxiliary source, such as another vehicle with the same system voltage or to another battery. The ...

4. Revive a Car's Dead Battery with These Top Jumper Cables - AOL

   www.aol.com/revive-cars-dead-battery-top...

   Connecting jumper cables between car batteries is straightforward—red/positive to positive and black/negative to negative—and almost all jumper cables are color coded. ... a 12-volt battery ...

5. Crocodile clip - Wikipedia

   en.wikipedia.org/wiki/Crocodile_clip

   Alligator clip A crocodile clip manufactured by Mueller Electric. This device is a variation of Dusinberre's original crocodile clip design Crocodile clips, also called automotive clips, on a set of jumper cables Three crocodile clips: a bare standard-sized clip; a miniature clip in a yellow plastic boot; a large red Square D multi-function clip

6. Jump wire - Wikipedia

   en.wikipedia.org/wiki/Jump_wire

   Stranded 22AWG jump wires with solid tips. A jump wire (also known as jumper, jumper wire, DuPont wire) is an electrical wire, or group of them in a cable, with a connector or pin at each end (or sometimes without them – simply "tinned"), which is normally used to interconnect the components of a breadboard or other prototype or test circuit, internally or with other equipment or components ...

7. List of battery sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_battery_sizes

   There were two ⌀3.2 mm negative pins spaced 9.5 mm apart and two ⌀4.0 mm positive pins spaced 14.3 mm apart. Negative and positive pins were spaced 18.1 mm apart. It was used in some early transistor radio amplifiers with a Class B output stage, allowing the loud speaker to be connected between the amplifier output and the battery center tap.