Search results
Results from the WOW.Com Content Network
The GY6 engine design is a four-stroke single-cylinder in a near-horizontal orientation that is used on a number of small motorcycles or scooters made in Taiwan, China, and other southeast Asian countries. It has since become a generic technology.
In addition, the transmission supports start-stop systems by including a spring-loaded hydraulic accumulator to engage the first-gear clutches upon restarting the engine. [6] The 8th gear ratio of the 9TXX corresponds to the 6th gear ratio of the 6T40, allowing lower engine speeds in 9th gear. [ 5 ]
Incorrect. While the Honda CH80 (found in Elite 80s) specs were similar to what is rumored to be the original GY6, there is a major difference: engine orientation. The GY6 design is very specific: it is a horizontal single cylinder forced air cooled overhead cam engine with built in CVT. The Honda CH80 orientation is vertical [1].
The propeller shaft linking gearbox and rear axle is thus overdriven, and a transmission capable of doing this became termed an "overdrive" transmission. [1] The device for achieving an overdrive transmission was usually a small separate gearbox, attached to the rear of the main gearbox and controlled by its own shift lever. [1]
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
Willow Run Assembly was a General Motors automobile factory near Ypsilanti, Michigan, located at 2625 Tyler Road, in the Willow Run manufacturing complex. Willow Run Assembly consisted of an assembly plant of 2.3 million square feet, another building that was known in later years as "Willow Run Company Vehicle Operations", covering 23,000 ...
The NV5600 is a Heavy Duty close ratio 6-speed manual transmission that was used in 1999-2005 Dodge RAM 2500 and 3500 Series ¾ ton and 1 ton Trucks with the 5.9L Cummins Engines. [1] It was manufactured by New Venture Gear, a division of Magna Powertrain.
This transmission, like single and dual range and dual coupling hydramatics, also has the feature of split torque in the transmission, whereby in fourth (or high) gear only 40% to 50% depending on transmission—40% in Roto's case—but because of the design the coupling is only required to carry 40% of the engine torque.