enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bushing (isolator) - Wikipedia

   en.wikipedia.org/wiki/Bushing_(isolator)

   A rubber bushing may also be described as a flexible mounting or antivibration mounting. These bushings often take the form of an annular cylinder of flexible material inside a metallic casing or outer tube. They might also feature an internal crush tube which protects the bushing from being crushed by the fixings which hold it onto a threaded ...

3. Induction shrink fitting - Wikipedia

   en.wikipedia.org/wiki/Induction_shrink_fitting

   Induction heating is a non contact heating process which uses the principle of electromagnetism induction to produce heat in a work-piece. In this case thermal expansion is used in a mechanical application to fit parts over one another, e.g. a bushing can be fitted over a shaft by making its inner diameter slightly smaller than the diameter of the shaft, then heating it until it fits over the ...

4. Threaded insert - Wikipedia

   en.wikipedia.org/wiki/Threaded_insert

   TIME-SERT insert. A threaded insert, also known as a threaded bushing, is a fastener element that is inserted into an object to add a threaded hole. [1] They may be used to repair a stripped threaded hole, provide a durable threaded hole in a soft material, place a thread on a material too thin to accept it, mold or cast threads into a work piece thereby eliminating a machining operation, or ...

5. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   Quick-disconnect (QD) bushings work similarly, but place a circular pattern of three unthreaded and three fully threaded holes further out from the shaft axis on a bushing flange, instead of across the bushing-to-hub interface. A Hirth joint is similar to a spline joint but with the teeth on the end of the shaft instead of on the surface.

6. Plain bearing - Wikipedia

   en.wikipedia.org/wiki/Plain_bearing

   A flanged bushing is a sleeve bushing with a flange at one end extending radially outward from the OD. The flange is used to positively locate the bushing when it is installed or to provide a thrust bearing surface. [9] Sleeve bearings of inch dimensions are almost exclusively dimensioned using the SAE numbering system.

7. Bushing - Wikipedia

   en.wikipedia.org/wiki/Bushing

   Bushing (bearing), a type of plain bearing; Bushing (electrical), an insulated device that allows a conductor to pass through a grounded conducting barrier; Bushing (isolator), a mechanical device used to reduce vibrational energy transfer between two parts; Drill bushing, a tool used to guide the placement of a hole when drilling in a workpiece