Search results
Results from the WOW.Com Content Network
Some early gas engines worked on the "vacuum" or "atmospheric" principle in a similar way to the Newcomen steam engine.A mixture of gas and air was eaten by the cylinder and ignited; the mixture expanded and part of it escaped through the exhaust valve; the valve then closed, the mixture cooled and contracted, and atmospheric pressure pushed the piston in.
The flame speeds are not the actual engine flame speeds, A 12:1 compression ratio gasoline engine at 1500 rpm would have a flame speed of about 16.5 m/s, and a similar hydrogen engine yields 48.3 m/s, but such engine flame speeds are also very dependent on stoichiometry [5]
The Chevrolet Stovebolt engine is a straight-six engine made in two versions between 1929 and 1962 by the Chevrolet Division of General Motors.It replaced the company's 171-cubic-inch (2.8 L) inline-four as their sole engine offering from 1929 through 1954, and was the company's base engine starting in 1955 when it added the small block V8 to the lineup.
This engine was fuelled by gas vapours, used the piston's intake stroke to draw in outside air, and the air/fuel mixture was ignited by an external flame. [6] Another gas engine was also patented in 1794 by Thomas Mead. [7] 1801: The concept of using compression in a two-stroke gas engine was theorised by French engineer Philippe LeBon D ...
In aviation, a flameout (or flame-out) is the run-down of a jet engine or other turbine engine due to the extinguishment of the flame in its combustor.The loss of flame can have a variety of causes, such as fuel starvation, excessive altitude, compressor stall, foreign object damage deriving from birds, hail, or volcanic ash, severe precipitation, mechanical failure, or very low ambient ...
The engines were also sold for marine and stationary applications. In a 1938 reorganization, Winton Engine Corporation became the GM Cleveland Diesel Engine Division, and GM's Detroit Diesel Engine Division began production of smaller (50–149 cu in (0.8–2.4 L) per cylinder) diesel engines. Locomotive engines were moved under the GM Electro ...
The flame would project into the main combustor fuel spray. Torch igniters were superseded by surface discharge igniter plugs with a considerably greater energy release rate than a flame. [4] The engine was run up to just over 4,000 lbf (18 kN), and a cheer went up around the assembled personnel.
Otherwise, the engine wastes the unburned fuel and creates unwanted emissions of unburned hydrocarbons, carbon monoxide (CO), and soot. Low pressure loss across the combustor. The turbine which the combustor feeds needs high-pressure flow to operate efficiently. The flame (combustion) must be held (contained) inside of the combustor.