Search results
Results from the WOW.Com Content Network
Velostat, also known as Linqstat, is a packaging material made of a polymeric foil (polyolefins) impregnated with carbon black to make it somewhat electrically conductive. It is used for the protection of items or devices that are susceptible to damage from electrostatic discharge. [1] It was developed by Custom Materials, now part of 3M. [2]
The TPRC List is the TPRC estimate for well annealed Lead of 99.99+% purity and residual electrical resistivity ρ 0 =0.000880 μΩ cm. TPRC Data Series Volume 1, page 191. [8] This material is superconductive (electrical) at temperatures below 7.193 Kelvins. Weast page E-87. [27] Limestone: 1.26 [19] - 1.33 [19] Indiana Limestone R 1.19 1.21 1 ...
Since most conductive polymers require oxidative doping, the properties of the resulting state are crucial. Such materials are salt-like (polymer salt), which makes them less soluble in organic solvents and water and hence harder to process. Furthermore, the charged organic backbone is often unstable towards atmospheric moisture.
PPV is a diamagnetic material and has a very low intrinsic electrical conductivity, on the order of 10-13 S/cm. [1] The electrical conductivity increases upon doping with iodine, ferric chloride, alkali metals, or acids. However, the stability of these doped materials is relatively low.
Thermal combustion is the most common source for carbon monoxide. Carbon monoxide is produced from the partial oxidation of carbon-containing compounds; it forms when there is not enough oxygen to produce carbon dioxide (CO 2), such as when operating a stove or an internal combustion engine in an enclosed space.
The resistance of a given conductor depends on the material it is made of, and on its dimensions. For a given material, the resistance is inversely proportional to the cross-sectional area. [1] For example, a thick copper wire has lower resistance than an otherwise-identical thin copper wire. Also, for a given material, the resistance is ...
For high voltage applications, a good dielectric gas should have high dielectric strength, high thermal stability and chemical inertness against the construction materials used, non-flammability and low toxicity, low boiling point, good heat transfer properties, and low cost. [1] The most common dielectric gas is air, due to its ubiquity and ...
For example, if A = 1 m 2, = 1 m (forming a cube with perfectly conductive contacts on opposite faces), then the resistance of this element in ohms is numerically equal to the resistivity of the material it is made of in Ω⋅m. Conductivity, σ, is the inverse of resistivity: