Search results
Results from the WOW.Com Content Network
The burning of a solid material may appear to lose weight if the mass of combustion gases (such as carbon dioxide and water vapor) are not taken into account. The original mass of flammable material and the mass of the oxygen consumed (typically from the surrounding air) equals the mass of the flame products (ash, water, carbon dioxide, and ...
Dusts also have upper and lower explosion limits, though the upper limits are hard to measure and of little practical importance. Lower flammability limits for many organic materials are in the range of 10–50 g/m 3 , which is much higher than the limits set for health reasons, as is the case for the LEL of many gases and vapours.
Below the water table, in the phreatic zone (zone of saturation), layers of permeable rock that yield groundwater are called aquifers. In less permeable soils, such as tight bedrock formations and historic lakebed deposits, the water table may be more difficult to define. “Water table” and “water level” are not synonymous. If a deeper ...
LHV calculations assume that the water component of a combustion process is in vapor state at the end of combustion, as opposed to the higher heating value (HHV) (a.k.a. gross calorific value or gross CV) which assumes that all of the water in a combustion process is in a liquid state after a combustion process.
Explosion of unserviceable ammunition and other military items The explosion of the Castle Bravo nuclear bomb. An explosion is a rapid expansion in volume of a given amount of matter associated with an extreme outward release of energy, usually with the generation of high temperatures and release of high-pressure gases. Explosions may also be ...
The flash point is a descriptive characteristic that is used to distinguish between flammable fuels, such as petrol (also known as gasoline), and combustible fuels, such as diesel. It is also used to characterize the fire hazards of fuels. Fuels which have a flash point less than 37.8 °C (100.0 °F) are called flammable, whereas fuels having a ...
Damage to buildings, equipment and people can result from a large-scale, short-duration deflagration. The potential damage is primarily a function of the total amount of fuel burned in the event (total energy available), the maximum reaction velocity that is achieved, and the manner in which the expansion of the combustion gases is contained.
A fuel explosion within the confines of the firebox may damage the pressurized boiler tubes and interior shell, potentially triggering structural failure, steam or water leakage, and/or a secondary boiler shell failure and steam explosion. A common form of minor firebox "explosion" is known as "drumming" and can occur with any type of fuel.