Search results
Results from the WOW.Com Content Network
These connectors had the same number of pins as the above DE-15 connectors, but used the more traditional pin size, pin spacing, and size shell of the DA-15 standard connector. "VGA adapters" (i.e. DA-15 to DE-15 dongles) were available but sometimes monitor-specific, or they needed DIP switch configuration, as the Macintosh's monitor sense ...
A diagram of the DB-25 connector. Date: 18 June 2006 (original upload date) Source: No machine-readable source provided. Own work assumed (based on copyright claims). Author: No machine-readable author provided. Mobius assumed (based on copyright claims). Other versions
An IEEE 1284 36-pin male micro ribbon printer cable connection. The computer side normally uses a DB-25 port instead of this connector. IEEE 1284, also known as the Centronics port, is a standard that defines bi-directional parallel communications between computers and other devices.
Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...
When IBM implemented the parallel interface on the IBM PC, they used the DB-25F connector at the PC-end of the interface, creating the now familiar parallel cable with a DB25M at one end and a 36-pin micro ribbon connector at the other. In theory, the Centronics port could transfer data as rapidly as 75,000 characters per second.
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
Early SCSI interfaces commonly used a 50-pin micro ribbon connector. This connector is similar to the 36-pin connector used by Centronics for the parallel interface on their printers, thus the connector became popularly known as "Centronics SCSI" or "CN-50". It is also referred to as a "SCSI-1 connector"; since many connectors have been used ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.