Search results
Results from the WOW.Com Content Network
For instances where the full-duplex nature of SPI is not used, an extension uses both data pins in a half-duplex configuration to send two bits per clock cycle. Typically a command byte is sent requesting a response in dual mode, after which the MOSI line becomes SIO0 (serial I/O 0) and carries even bits, while the MISO line becomes SIO1 and ...
In normal half-duplex operations late collisions do not occur. However, in a duplex mismatch the collisions seen on the half-duplex side of the link are often late collisions. The full-duplex side usually will register frame check sequence errors, or runt frames. [7] [8] Viewing these standard Ethernet statistics can help diagnose the problem.
A unique characteristic of SDLC is its ability to mix half-duplex secondary stations with full-duplex primary stations on four-wire circuits, thus reducing the cost of dedicated facilities. [ 6 ] This de facto standard has been adopted by ISO as High-Level Data Link Control (HDLC) in 1979 [ 4 ] and by ANSI as Advanced Data Communication Control ...
CSMA/CD is still supported for backwards compatibility and for half-duplex connections. The IEEE 802.3 standard, which defines all Ethernet variants, for historical reasons still bore the title "Carrier sense multiple access with collision detection (CSMA/CD) access method and physical layer specifications" until 802.3-2008, which uses new name ...
Autonegotiation can be used by devices that are capable of more than one transmission rate, different duplex modes (half duplex and full duplex), and different transmission standards at the same speed (though in practice only one standard at each speed is widely supported).
802.11 networks in infrastructure mode are half-duplex; all stations share the medium. In infrastructure or access point mode, all traffic has to pass through an Access Point (AP). Thus, two stations on the same access point that are communicating with each other must have each and every frame transmitted twice: from the sender to the access ...
Before signaling will work, the sender and receiver must agree on the signaling parameters: Full or half-duplex operationThe number of bits per character -- currently almost always 8-bit characters, but historically some transmitters have used a five-bit character code, six-bit character code, or a 7-bit ASCII.
Parallel SCSI (formally, SCSI Parallel Interface, or SPI) is the earliest of the interface implementations in the SCSI family. SPI is a parallel bus ; there is one set of electrical connections stretching from one end of the SCSI bus to the other.