Search results
Results from the WOW.Com Content Network
A bright-field microscope has many important parts including; the condenser, the objective lens, the ocular lens, the diaphragm, and the aperture. Some other pieces of the microscope that are commonly known are the arm, the head, the illuminator, the base, the stage, the adjusters, and the brightness adjuster.
The damage on the metal sheet, wear mode, or characteristic pattern shows no breakthrough of the oxide surface layer, which indicates a small amount of adhesive material transfer and flattening damage of the sheet's surface. This is the first stage of material transfer and galling build-up.
Diagram illustrating the light path through a dark-field microscope. The steps are illustrated in the figure where an inverted microscope is used. Light enters the microscope for illumination of the sample. A specially sized disc, the patch stop (see figure), blocks some light from the light source, leaving an outer ring of illumination. A wide ...
A condenser between the stage and mirror of a vintage microscope. Condensers are located above the light source and under the sample in an upright microscope, and above the stage and below the light source in an inverted microscope. They act to gather light from the microscope's light source and concentrate it into a cone of light that ...
Antonie van Leeuwenhoek (1632–1723). The field of microscopy (optical microscopy) dates back to at least the 17th-century.Earlier microscopes, single lens magnifying glasses with limited magnification, date at least as far back as the wide spread use of lenses in eyeglasses in the 13th century [2] but more advanced compound microscopes first appeared in Europe around 1620 [3] [4] The ...
At high engine speeds over-speeding and over-temperaturing (going beyond the maximum allowable) must be prevented to avoid turbine blade damage. [21] An example of an HMU, although called a Constant All Speed Control (CASC), was the Rolls-Royce/Lucas fuel control used on the Rolls-Royce Spey. It performed all the above functions as well as ...
Fluorescence and confocal microscopes operating principle. Confocal microscopy, most frequently confocal laser scanning microscopy (CLSM) or laser scanning confocal microscopy (LSCM), is an optical imaging technique for increasing optical resolution and contrast of a micrograph by means of using a spatial pinhole to block out-of-focus light in image formation. [1]
A set of standard 75 by 25 mm microscope slides. The white area can be written on to label the slide. A microscope slide (top) and a cover slip (bottom) A microscope slide is a thin flat piece of glass, typically 75 by 26 mm (3 by 1 inches) and about 1 mm thick, used to hold objects for examination under a microscope.