Search results
Results from the WOW.Com Content Network
A cam engine is a reciprocating engine where instead of the conventional crankshaft, the pistons deliver their force to a cam that is then caused to rotate. The output work of the engine is driven by this cam. [1] A variation of the cam engine, the swashplate engine (also the closely related wobble-plate engine), was briefly popular. [2]
Two-stroke engines often have a higher power-to-weight ratio than a four-stroke engine, since their power stroke occurs twice as often. Two-stroke engines can also have fewer moving parts, and thus be cheaper to manufacture and weigh less. In countries and regions with stringent emissions regulation, two-stroke engines have been phased out in ...
The engine configuration describes the fundamental operating principles by which internal combustion engines are categorized. Piston engines are often categorized by their cylinder layout, valves and camshafts. Wankel engines are often categorized by the number of rotors present. Gas turbine engines are often categorized into turbojets ...
The four-stroke engine is more efficient when running at full throttle, while the opposite is the case for the two-stroke engine. When a small car under heavy load runs at half speed, the engine automatically switches to the two-cycle mode, which is then more efficient. The research on this showed a 27% reduction in fuel consumption. [8] [9]
Scavenging is the process of replacing the exhaust gas in a cylinder of an internal combustion engine with the fresh air–fuel mixture (or fresh air, in the case of direct-injection engines) for the next cycle. If scavenging is incomplete, the remaining exhaust gases can cause improper combustion for the next cycle, leading to reduced power ...
A stroke is the action of a piston travelling the full length of its cylinder.In a two-stroke engine, one of the two strokes combines primarily the intake stroke and the combustion stroke, while the other stroke primarily combines the compression stroke and the exhaust stroke, though technically since both ports are exposed during both the combustion and compression strokes, some reversion ...
With the basic design of the engine already frozen, Cosworth's work included revising the port and camshaft shapes and extensive development work with a focus on reliability. Based on a 2.0E block with bore and stroke of 95.2 mm × 85 mm (3.7 in × 3.3 in), the engine displaced 2,420 cc (147.7 cu in). [9] Compression was 11.5:1.
A cam-in-block engine is where the camshaft is located in the engine block. Types of cam-in-block engines are: F-Head Engine; Flathead engine; Overhead valve engine (the only type where the valves are above the combustion chamber) T-head engine