Search results
Results from the WOW.Com Content Network
An open single-cavity bullet mold and a closed two-cavity mold. A cast bullet is made by allowing molten metal to solidify in a mold.Most cast bullets are made of lead alloyed with tin and antimony; but zinc alloys have been used when lead is scarce, and may be used again in response to concerns about lead toxicity.
Cast bullets as cast (left), with gas check (center) and lubricated (right). A gas check is a gasket type component of firearms ammunition. Gas checks are used when non-jacketed bullets are used in high pressure cartridges. The use of a gas check inhibits the buildup of lead in the barrel and improves accuracy. [1]
The .444 Marlin (10.9×57mmR) is a rifle cartridge designed in 1964 by Marlin Firearms and Remington Arms.It was designed to fill the gap left when the older .45-70 cartridge was not available in new lever-action rifles; at the time it was the largest lever-action cartridge available. [1]
Marlin Model 2000, a .22 LR bolt-action rifle, designed for competition target shooting (biathlon version available) Marlin Model MR7, a long action center fire bolt-action rifle available in .30-06, .270,and .25-06 manufactured from 1996-1999 A few were offered in .280 Remington in 1999
The .351 SL cartridge used an unusual bullet diameter of .351 instead of the .357 or .358 more commonly used in .35-caliber rifle cartridges. [6] Most ammunition available today for the .351 SL is produced by a few boutique manufacturers, often using either cast lead bullets or copper-plated bullets or, occasionally, .358 jacketed bullets ...
The .405 Winchester / 10.45x65mmR (.405 WCF) is a rimmed centerfire rifle cartridge introduced in 1904 for the Winchester 1895 lever-action rifle. [4] It remains to this day one of the most powerful rimmed cartridges designed specifically for lever-action rifles; the only modern lever action cartridges that exceed its performance are the .50 Alaskan, .450 Alaskan, .475 Turnbull, .348 Turnbull ...
In 1980, continued production of the ammunition was turned over to the North American Ordnance Corporation. The production of KTW-branded ammunition eventually ceased in the 1990s. However, some manufacturers continue to coat their bullets with various compounds, notably Teflon and molybdenum disulfide, as a protective layer against barrel wear.
Most factory ammunition exhibits ballistics of about 1,200 ft/s (370 m/s) and 325 ft⋅lbf (441 J) of energy at the muzzle with a 100-grain (6.5 g) bullet from an 18 to 20 inch rifle barrel. The performance characteristics of the cartridge listed in the sidebar should be considered maximum performance parameters obtainable, and even then only ...