enow.com Web Search

  1. Ad

    related to: framing bit holder for concrete slab floor

Search results

  1. Results from the WOW.Com Content Network
  2. Hold down (structural engineering) - Wikipedia

    en.wikipedia.org/wiki/Hold_down_(structural...

    A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...

  3. Lift slab construction - Wikipedia

    en.wikipedia.org/wiki/Lift_slab_construction

    Lift slab construction (also called the Youtz-Slick Method) is a method of constructing concrete buildings by casting the floor or roof slab on top of the previous slab and then raising (jacking) the slab up with hydraulic jacks. This method of construction allows for a large portion of the work to be completed at ground level, negating the ...

  4. Bore Through Tough Concrete and Brick With These Masonry ...

    www.aol.com/lifestyle/bore-tough-concrete-brick...

    4-Cutter SDS+ Carbide Hammer Drill Bit Masonry Kit. If you plan on drilling through concrete with rebar, save yourself time and money by using these heavy-duty Milwaukee bits.

  5. Framing (construction) - Wikipedia

    en.wikipedia.org/wiki/Framing_(construction)

    Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a

  6. Open web steel joist - Wikipedia

    en.wikipedia.org/wiki/Open_web_steel_joist

    The CJ-Series Joists are capable of supporting larger floor or roof loadings due to the attachment of the concrete slab to the top chord of the composite joist. Shear connection between the concrete slab and steel joist is typically made by the welding of shear studs through the steel deck to the underlying CJ-Series Composite Steel Joist. [2]

  7. Concrete slab - Wikipedia

    en.wikipedia.org/wiki/Concrete_slab

    Typically concrete slabs perform better than implied by their R-value. [5] The R-value does not consider thermal mass, since it is tested under constant temperature conditions. Thus, when a concrete slab is subjected to fluctuating temperatures, it will respond more slowly to these changes and in many cases increase the efficiency of a building ...

  8. Joist - Wikipedia

    en.wikipedia.org/wiki/Joist

    A double floor is a floor framed with joists supported by larger timbers.. In traditional timber framing there may be a single set of joists which carry both a floor and ceiling called a single floor (single joist floor, single framed floor) or two sets of joists, one carrying the floor and another carrying the ceiling called a double floor (double framed floor).

  9. Filigree concrete - Wikipedia

    en.wikipedia.org/wiki/Filigree_concrete

    The Filigree Wideslab method is a process for construction of concrete floor decks from two interconnected concrete placements, one precast in a factory, and the other done in the field. The method was developed during the late 1960s by Harry H. Wise as a more efficient and economic construction process than conventional cast-in-place technologies.

  1. Ad

    related to: framing bit holder for concrete slab floor