Ads
related to: girder clamps for lifting concreteebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
Strandjack at Freybridge in Berlin–Spandau 52° 30′ 42,11″ N, 13° 12′ 11,7″ O. A strand jack (also known as strandjack) is a jack used to lift very heavy loads (e.g. thousands of tons or more with multiple jacks) for construction and engineering purposes. [1]
Once several bridge piers are complete, support brackets are attached to adjacent piers and the main parallel girders of the MSS are lifted in place to support the scaffold and concrete forms. Jacks are used to raise the girders and forms and the concrete is poured for the segment (or span) after rebar is placed. After the concrete has cured ...
As the orientation of the void determines the lift position of the lifting clutch, the wire chair can be secured against the element reinforcement to maintain this orientation during the concrete pour and set. When an anchors load resistance must consider load reduction factors, this would imply that the particular selected anchor will form a ...
A rolled steel girder is a girder that has been fabricated by rolling a blank cylinder of steel through a series of dies to create the desired shape. These create standardized I-beam and wide flange beam [7] shapes up to 100 feet in length. A plate girder is a girder that has been fabricated by welding plates together to create the desired ...
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around the pipe, and integral fasteners are then tightened to clamp them onto the pipe.
Precast parking structure showing an interior column, girders, and double-tee structural floors. The two gray circles are covers to close the lifting anchor holes. Precast concrete building components and site amenities are used architecturally as fireplace mantels, cladding, trim products, accessories and curtain walls.
A girder (/ ˈ ɡ ɜːr d ər /) is a beam used in construction. [1] It is the main horizontal support of a structure which supports smaller beams. Girders often have an I-beam cross section composed of two load-bearing flanges separated by a stabilizing web, but may also have a box shape, Z shape, or other forms. Girders are commonly used to ...
Ads
related to: girder clamps for lifting concreteebay.com has been visited by 1M+ users in the past month