Search results
Results from the WOW.Com Content Network
When the 351 Cleveland was discontinued after the 1974 model year, Ford needed another engine in that size range, since production of the 351 Windsor was not sufficient. Ford took the 400 engine's tall-deck block and installed a crankshaft with a shorter 3.5 in (89 mm) stroke to produce a 351 cubic inches (5.8 L) engine.
Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and ...
Ford 351 may refer to: Ford 351 Windsor (351W), an engine part of the Ford 90 degree V family; Ford 351 Cleveland (351C), an engine part of the Ford 335 family; Ford ...
With the rev limiter disabled it is theoretically capable of 252 km/h (157 mph) and can exceed 7,000 rpm in fourth gear. The rev limiter is set to 6,150 rpm. The engine type was a 351 Cleveland (carried over from the XW GT/GT-HO Phase II). While Ford stated an output of 300 horsepower, the engine was reputed to produce over 350 horsepower.
Two additional displacements were produced during the engine's history. A 351 cu in (5.8 L) model was offered beginning in 1969 and continuing until 1996. The 351W (so identified to distinguish from the 335-series Cleveland-produced 351C) uses a taller block than the other engines in the series to avoid excessively short connecting rods. And ...
The 302 Cleveland was a destroked 351 Cleveland built using tooling exported to Australia after the closure of the Cleveland production line. The F-100 with a 302 Cleveland model was the first Australian Sixth Gen to receive an automatic transmission as an option, the six cylinder powered models and the larger F-250 and F-350 were limited to a ...
1973 Ford Mustang convertible 351-2V Cleveland. The 2V refers to the single 2-barrel carburettor - all Clevelands were 2-valve engines. Date: 26 August 2006: Source: 28th annual New England Regional All-Ford Show and Swap Meet hosted by the Mustang Car Club of New England at the Hebert Candy Mansion, Shrewsbury, MA: Author
1975–2007 Ford-Cosworth Indy V8 engine (U.S.A.C. IndyCar engine) 1970–1982 335/Cleveland V8— small-block (351 Cleveland/400/351M/Boss 351) 1969–1982 Ford Australia produced Cleveland V8 engines 302/351 (Geelong plant) 1983–2010 Ford/Navistar Diesel V8. 1983–1987—6.9 L IDI (indirect injection) 1988–1993—7.3 L IDI