Search results
Results from the WOW.Com Content Network
An ICD is the umbrella document over the system interfaces; examples of what these interface specifications should describe include: The inputs and outputs of a single system, documented in individual SIRS (Software Interface Requirements Specifications) and HIRS (Hardware Interface Requirements Specifications) documents, would fall under "The Wikipedia Interface Control Document".
A process is composed of tasks that are connected with sequence flows. Processes represent an execution flow. The graphical diagram of a process is used as the basis for the communication between non-technical users and developers. Each execution of a process definition is called a "process instance". jBPM manages the process instances.
In computer programming, create, read, update, and delete (CRUD) are the four basic operations (actions) of persistent storage. [1] CRUD is also sometimes used to describe user interface conventions that facilitate viewing, searching, and changing information using computer-based forms and reports.
The control action is the switching on/off of the boiler, but the controlled variable should be the building temperature, but is not because this is open-loop control of the boiler, which does not give closed-loop control of the temperature. In closed loop control, the control action from the controller is dependent on the process output.
A modern control room where plant information and controls are displayed on computer graphics screens. The operators are seated as they can view and control any part of the process from their screens, whilst retaining a plant overview. Process control of large industrial plants has evolved through many stages.
While IEEE 488.2 provided a device-independent syntax, there was still no standard for instrument-specific commands. Commands to control the same class of instrument, e.g., multimeters, would vary between manufacturers and even models. The United States Air Force, [9] and later Hewlett-Packard, recognized this problem.
For continuously modulated control, a feedback controller is used to automatically control a process or operation. The control system compares the value or status of the process variable (PV) being controlled with the desired value or setpoint (SP), and applies the difference as a control signal to bring the process variable output of the plant ...
SIMD instruction s, a single instruction performing an operation on many homogeneous values in parallel, possibly in dedicated SIMD registers; performing an atomic test-and-set instruction or other read–modify–write atomic instruction; instructions that perform ALU operations with an operand from memory rather than a register