Search results
Results from the WOW.Com Content Network
Diesel engines are used in aircraft, automobiles, power generation, diesel–electric locomotives, and both surface ships and submarines. The Diesel cycle is assumed to have constant pressure during the initial part of the combustion phase (to in the diagram, below). This is an idealized mathematical model: real physical diesels do have an ...
The thermodynamic cycle of the basic combined cycle consists of two power plant cycles. One is the Joule or Brayton cycle which is a gas turbine cycle and the other is the Rankine cycle which is a steam turbine cycle. [5] The cycle 1-2-3-4-1 which is the gas turbine power plant cycle is the topping cycle. It depicts the heat and work transfer ...
The plant brings generator sets online and takes them offline depending on the demands of the system at a given time. An islanded power plant intended for a primary power source of an isolated community will often have at least three diesel generators, any two of which are rated to carry the required load. Groups of up to 20 are not uncommon.
Load-following power plants can be hydroelectric power plants, diesel and gas engine power plants, combined cycle gas turbine power plants and steam turbine power plants that run on natural gas or heavy fuel oil, although heavy fuel oil plants make up a very small portion of the energy mix. A relatively efficient model of gas turbine that runs ...
Most electric power plants use some of the electricity they produce to operate the power plant. Net generation excludes the electricity used for the operation of the power plant. Capacity—the maximum level of electric power (electricity) that a power plant can supply at a specific point in time under certain conditions. [1]
Some ships even have three different gear ratios for the diesel engines — one each for single-diesel and double-diesel cruises, and the third when the gas turbine is engaged. Such a propulsion system has a smaller footprint than a diesel-only power plant with the same maximal power output, since smaller engines can be used and the gas turbine ...
A turbo-electric COGAS power-plant. In this way, some of the otherwise lost energy can be reclaimed and the specific fuel consumption of the plant can be decreased. Large (land-based) electric powerplants built using this combined cycle can reach conversion efficiencies of over 60%. [1]
Non-renewable power stations are those that run on coal, fuel oils, nuclear fuel, natural gas, oil shale and peat, while renewable power stations run on fuel sources such as biomass, geothermal heat, hydro, solar energy, solar heat, tides and the wind. Only the most significant fuel source is listed for power stations that run on multiple sources.