Search results
Results from the WOW.Com Content Network
For security, additional latching points may be added. For example, upper and lower vertical rods added to one door and connected to the leaf with no rods via a mortice latch. A double door coordinator is used to ensure the active leaf does not close before the inactive leaf. This configuration is not recommended for high traffic locations. [9]
A push switch (button) is a momentary or non-latching switch which causes a temporary change in the state of an electrical circuit only while the switch is physically actuated. An automatic mechanism (i.e. a spring ) returns the switch to its default position immediately afterwards, restoring the initial circuit condition.
A door closer is a mechanical device that regulates the speed and action of a door’s swing. [1] Manual closers store the force used to open the door in some type of spring and reuse it to close the door. Automatic types use electricity to regulate door swing behavior. Door closers can be linked to a building's fire and security alarm systems. [2]
An electric strike is an access control device used for door frames. It replaces the fixed strike faceplate often used with a latch (also known as a keeper). Like a fixed strike plate, it normally presents a ramped or beveled surface to the locking latch allowing the door to close and latch just like a fixed strike would.
Metal fire-resistance rated door with a lockset consisting of a locking latch bolt operated by lever handle with an escutcheon that encompasses the locking mechanism.. A lockset (alternatively lock set) is the hardware and components that make up the locking or latching mechanism that can usually be found on a door or other hinged object but can also include sliding doors and dividers. [1]
Mortise locks may include a non-locking sprung latch operated by a door handle. Such a lock is termed a sash lock. A simpler form without a handle or latch is termed a dead lock. Dead locks are commonly used as a secure backup to a sprung non-deadlocking latch, usually a pin tumbler rim lock. [note 1] [according to whom?]
Three point lock are also commonly used in wardrobes, like from Hettich [6] [7] Single-point locking may provide adequate security for some situations on tiered lockers, as the doors are shorter, and therefore more difficult to force open; however, the taller doors of full length lockers and cabinets are more susceptible to the application of leverage.
Typical single door electromagnetic locks are offered in both 600 lbf (2,700 N) and 1,200 lbf (5,300 N) dynamic holding force capacities. A "fail safe" magnetic lock requires power to remain locked and typically is not suitable for high security applications, because it is possible to disable the lock by disrupting the power supply.