Search results
Results from the WOW.Com Content Network
Examples of computer clip art, from Openclipart. Clip art (also clipart, clip-art) is a type of graphic art. Pieces are pre-made images used to illustrate any medium. Today, clip art is used extensively and comes in many forms, both electronic and printed. However, most clip art today is created, distributed, and used in a digital form.
The torque tube design is typically heavier and securely ties the rear end together, thus providing a rigid rear end and assuring good alignment under all conditions. However, because of the greater unsprung weight of the torque tube and radius rods, there may be a "little hopping around of the rear end when cornering fast or on washboard roads".
The circle of forces, traction circle, friction circle, [1] or friction ellipse [2] [3] [4] is a useful way to think about the dynamic interaction between a vehicle's tire and the road surface. The diagram below shows the tire from above, so that the road surface lies in the xy - plane .
Geometric roll center is solely dictated by the suspension geometry, and can be found using principles of the instant center of rotation.; Force based roll center, according to the US Society of Automotive Engineers, is "The point in the transverse vertical plane through any pair of wheel centers at which lateral forces may be applied to the sprung mass without producing suspension roll".
A similar method like this was used in the late 1930s by Buick and by Hudson's bathtub car in 1948, which used helical springs that could not take fore-and-aft thrust. The Hotchkiss drive , invented by Albert Hotchkiss, was the most popular rear suspension system used in American cars from the 1930s to the 1970s.
Stirrup sample. Stirrups form the outer part of a rebar cage. The function of stirrups (often referred to as 'reinforcing steel links' and 'shear links') is threefold: to give the main reinforcement bars structure, to maintain a correct level of concrete cover, and to maintain an equal transferance of force throughout the supporting elements. [31]
The lateral force variation can be expressed as a peak-to-peak value, which is the maximum minus minimum value, or any harmonic value as described above. Lateral force is signed, such that when mounted on the vehicle, the lateral force may be positive, making the vehicle pull to the left, or negative, pulling to the right.
In (automotive) vehicle dynamics, slip is the relative motion between a tire and the road surface it is moving on. This slip can be generated either by the tire's rotational speed being greater or less than the free-rolling speed (usually described as percent slip), or by the tire's plane of rotation being at an angle to its direction of motion (referred to as slip angle).