Search results
Results from the WOW.Com Content Network
To get better CPI values without pipelining, the number of execution units must be greater than the number of stages. For example, with six executions units, six new instructions are fetched in stage 1 only after the six previous instructions finish at stage 5, therefore on average the number of clock cycles it takes to execute an instruction ...
When a program wants to time its own operation, it can use a function like the POSIX clock() function, which returns the CPU time used by the program. POSIX allows this clock to start at an arbitrary value, so to measure elapsed time, a program calls clock(), does some work, then calls clock() again. [1] The difference is the time needed to do ...
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
Further, a "cumulative clock rate" measure is sometimes assumed by taking the total cores and multiplying by the total clock rate (e.g. a dual-core 2.8 GHz processor running at a cumulative 5.6 GHz). There are many other factors to consider when comparing the performance of CPUs, like the width of the CPU's data bus , the latency of the memory ...
Its only purpose is to measure execution time (flat profiling), and to do this interactively from the debug console (i.e. on a single function). As it is said several times in this text; the timing is not accurate and it should only be used as a coarse measure of the approximate run time and load of a function.
Floating point operations per second (FLOPS, flops or flop/s) is a measure of computer performance in computing, useful in fields of scientific computations that require floating-point calculations. [1] For such cases, it is a more accurate measure than measuring instructions per second. [citation needed]
The response time is the sum of three numbers: [3] Service time - How long it takes to do the work requested. Wait time - How long the request has to wait for requests queued ahead of it before it gets to run. Transmission time – How long it takes to move the request to the computer doing the work and the response back to the requestor.
Profilers interrupt program execution to collect information, which may result in a limited resolution in the time measurements, which should be taken with a grain of salt. Basic block profilers report a number of machine clock cycles devoted to executing each line of code, or a timing based on adding these together; the timings reported per ...