Search results
Results from the WOW.Com Content Network
Coarse diamond sharpening stones can be used for flattening waterstones. [8] [9]) Alternatively, tungsten carbide blades can be used in knife sharpening. A clamp-on knife sharpener. The rod guides the sharpening stone to maintain a consistent angle. The angle can be adjusted by moving the guide posts up or down.
Sharpening these implements can be expressed as the creation of two intersecting planes which produce an edge that is sharp enough to cut through the target material. For example, the blade of a steel knife is ground to a bevel so that the two sides of the blade meet. This edge is then refined by honing until the blade is capable of cutting.
Grinding turbine blades [8] Grinding honeycomb metals for aerospace application [8] Sharpening hypodermic needles [8] Machining carbide cutting-tool inserts [8] ECG is used to remove surface defects from parts where excessive material removal and residual stresses are undesired, such as re-profiling locomotive gears [8]
Tungsten carbide (chemical formula: WC) is a chemical compound (specifically, a carbide) containing equal parts of tungsten and carbon atoms. In its most basic form, tungsten carbide is a fine gray powder, but it can be pressed and formed into shapes through sintering [7] for use in industrial machinery, engineering facilities, [8] molding blocks, [9] cutting tools, chisels, abrasives, armor ...
The blade is made of non-rustproof carbon steel, blue-plastered by hand and finely forged from the base to the tip of the knife. The 90 mm (3.5 in) long blade shows patina (dark spots) caused by decades of use. It can easily be sharpened to a shaving sharp edge. Carbon steel is a popular choice for rough-use knives and cheaper options.
Due to the thin blade body the blades must be stabilized to minimize the side vibration amplitudes. When the first experiments with carbide saws were made, a development engineer of Advanced Machine & Engineering in Rockford stabilized the blade by using a broomstick which he pushed against the vibrating blade, minimizing the vibrations.
The coefficient of thermal expansion of cemented tungsten carbide is found to vary with the amount of cobalt used as a metal binder. For 5.9% cobalt samples, a coefficient of 4.4 μm/m·K was measured, whereas 13% cobalt samples have a coefficient of around 5.0 μm/m·K.
To differentially temper a blade, it is first quenched to harden the entire blade evenly. The blade is then heated in a localized area, allowing the heat to flow toward the edge. With single-edged blades, the blade may be tempered with fire or a torch. The blade is heated along the spine and tang only, allowing the heat to conduct to the edge.