Search results
Results from the WOW.Com Content Network
In wired networks, the hop count refers to the number of networks or network devices through which data passes between source and destination (depending on routing protocol, this may include the source/destination, that is, the first hop is counted as hop 0 or hop 1 [1]). Thus, hop count is a rough measure of distance between two hosts.
MTR is an enhanced version of ICMP traceroute available for Unix-like and Windows systems. The various implementations of traceroute all rely on ICMP Time Exceeded (type 11) packets being sent to the source. On Linux, tracepath is a utility similar to traceroute, with the primary difference of not requiring superuser privileges. [12]
Multi-path routing can be used in conjunction with most routing protocols because it is a per-hop local decision made independently at each router. It can substantially increase bandwidth by load-balancing traffic over multiple paths; however, there may be significant problems in deploying it in practice. [1]
Distance-vector protocols update the routing tables of routers and determine the route on which a packet will be sent by the next hop which is the exit interface of the router and the IP address of the interface of the receiving router. Distance is a measure of the cost to reach a certain node.
In link-state routing protocols, each router possesses information about the complete network topology. Each router then independently calculates the best next hop from it for every possible destination in the network using local information of the topology. The collection of best next hops forms the routing table.
The advantages of PathPing over ping and traceroute are that each node is pinged as the result of a single command, and that the behavior of nodes is studied over an extended time period, rather than the default ping sample of four messages or default traceroute single route trace. The disadvantage is that it takes a total of 25 seconds per hop ...
With hop-by-hop transport, chunks of data are forwarded from node to node in a store-and-forward manner. As hop-by-hop transport involves not only the source and destination node, but rather some or all of the intermediate nodes as well, it allows data to be forwarded even if the path between source and destination is not permanently connected ...
Source routing allows easier troubleshooting, improved traceroute, and enables a node to discover all the possible routes to a host. It does not allow a source to directly manage network performance by forcing packets to travel over one path to prevent congestion on another.