Search results
Results from the WOW.Com Content Network
The first production engine with a variable compression ratio was introduced in 2019. Variable compression ratio is a technology to adjust the compression ratio of an internal combustion engine while the engine is in operation. This is done to increase fuel efficiency while under varying loads. Variable compression engines allow the volume ...
In aeronautical engineering, overall pressure ratio, or overall compression ratio, is the amount of times the pressure increases due to ram compression and the work done by the compressor stages. The compressor pressure ratio is the ratio of the stagnation pressures at the front and rear of the compressor of a gas turbine .
Variable compression ratio (VCR) is a technology to adjust the compression ratio of an internal combustion engine while the engine is in operation. This is done to increase fuel efficiency while under varying loads. Variable compression engines allow the volume above the piston at top dead centre to be changed. Higher loads require lower ratios ...
Engines using the Diesel cycle are usually more efficient, although the Diesel cycle itself is less efficient at equal compression ratios. Since diesel engines use much higher compression ratios (the heat of compression is used to ignite the slow-burning diesel fuel), that higher ratio more than compensates for air pumping losses within the engine.
However, a real diesel engine will be more efficient overall since it will have the ability to operate at higher compression ratios. If a petrol engine were to have the same compression ratio, then knocking (self-ignition) would occur and this would severely reduce the efficiency, whereas in a diesel engine, the self ignition is the desired ...
The engine pressure ratio (EPR) is the total pressure ratio across a jet engine, measured as the ratio of the total pressure at the exit of the propelling nozzle divided by the total pressure at the entry to the compressor. [1] Jet engines use either EPR or compressor/fan RPM as an indicator of thrust. [2]
This can be achieved by modifying the air-fuel mixture drawn into the engine, modifying the static or dynamic compression ratio of the engine, modifying the fuel used (e.g. higher octane, different fuel types or chemistries), injection of water or methanol, modifying the timing and dwell of ignition events, and compressing the intake air.
Cetane numbers are rather difficult to measure accurately, as it requires a special diesel engine called a Cooperative Fuel Research (CFR) engine. Under standard test conditions, the operator of the CFR engine uses a manual-wheel to increase the compression ratio (and therefore the peak pressure within the cylinder) of the engine until the time ...