enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Standing wave ratio - Wikipedia

    en.wikipedia.org/wiki/Standing_wave_ratio

    Although the same information could be obtained by measuring the load's impedance with an impedance analyzer (or "impedance bridge"), the SWR meter is simpler and more robust for this purpose. By measuring the magnitude of the impedance mismatch at the transmitter output it reveals problems due to either the antenna or the transmission line.

  3. Antenna analyzer - Wikipedia

    en.wikipedia.org/wiki/Antenna_analyzer

    An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ-269, MFJ Enterprises Inc. An antenna analyzer or in British aerial analyser (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the input impedance of antenna systems in radio electronics applications.

  4. Antenna tuner - Wikipedia

    en.wikipedia.org/wiki/Antenna_tuner

    Cross-needle SWR meter on antenna tuner. It is a common misconception that a high standing wave ratio (SWR) per se causes loss. [3] A well-adjusted ATU feeding an antenna through a low-loss line may have only a small percentage of additional loss compared with an intrinsically matched antenna, even with a high SWR (4:1, for example). [21]

  5. Antenna measurement - Wikipedia

    en.wikipedia.org/wiki/Antenna_measurement

    An antenna designer must take into account the application for the antenna when determining the gain. High-gain antennas have the advantage of longer range and better signal quality, but must be aimed carefully in a particular direction. Low-gain antennas have shorter range, but the orientation of the antenna is inconsequential.

  6. SWR meter - Wikipedia

    en.wikipedia.org/wiki/SWR_meter

    An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).

  7. Log-periodic antenna - Wikipedia

    en.wikipedia.org/wiki/Log-periodic_antenna

    The log-periodic is commonly used as a transmitting antenna in high power shortwave broadcasting [15] stations because its broad bandwidth allows a single antenna to transmit on frequencies in multiple bands. The log-periodic zig-zag design with up to 16 sections has been used.

  8. Image credits: astarisaslave #8. TIL in South Korea, only blind people can get a masseur's license. This law was established in 1912, to help visually impaired people earn a living.

  9. Mast radiator - Wikipedia

    en.wikipedia.org/wiki/Mast_radiator

    The high reactance vs the low resistance give the antenna a high Q factor; the antenna and coil act as a high Q tuned circuit, reducing the usable bandwidth of the antenna. At lower frequencies mast radiators are replaced by more elaborate capacitively toploaded antennas such as the T antenna or umbrella antenna which can have higher efficiency.