Ads
related to: mitre box for large skirting metal frame woodebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A mitre box or miter box (American English) is a wood working appliance used to guide a hand saw for making precise cuts, usually 45° mitre cuts. [1] [2] Traditional mitre boxes are simple in construction and made of wood, while adjustable mitre boxes are made of metal and can be adjusted for cutting any angle from 45° to 90°.
Chalk line or ink line used to snap lines on the wood. Ink and a slurry of charcoal were used like chalk. Carpenter pencil; Scratch awl or similar tools were used to scratch lines on wood before the pencil was commonly used beginning in the 19th century in the U.S. Try square; Steel square is also known as a framing square. Historically a ...
Miter squares are usually made from two fixed parts, a stock and a blade (sometimes called a tongue). The blade on a modern factory-made miter square is typically a thin piece of metal which is fixed at 45° onto or into the stock, forming a 'T' shape. The stock is usually much thicker than the blade and is made from wood, metal or plastic.
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
[citation needed] The screws go under the frame (work-piece) to be held, and the bit clamps down on the lower-edge of the frame. [citation needed] Recent designs are more complicated; a rigid body holds one fixed and one moveable jaw activated by a cam. [citation needed] An example of newer clamps is Jim Chestnut's Clam Clamp. [8]
Mitre square: A mitre square is used in woodworking to mark and measure 45° angles and its supplementary angle, 135°. The most common type (pictured) has a tongue set at 45° to the stock. Factory-made mitre squares usually have a metal tongue and a wooden stock, though historically woodworkers would often make their own out of wood. [16]
This design can be used for cutting mitres (angle cuts) as well as regular crosscutting, and can be well suited to precisely cutting small pieces of wood. [ 4 ] If suitably square and flush, the stop that spans the full width of the bench hook (the hook) can also be used as a fence so the bench hook can be used as a short shooting board , for ...
Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door. A typical panel would be cut to allow 1/4" (5 mm) between itself and the bottom of the groove in the frame ...
Ads
related to: mitre box for large skirting metal frame woodebay.com has been visited by 1M+ users in the past month