Search results
Results from the WOW.Com Content Network
The most common use of a pull switch is to operate a ceiling electric light.The ceiling fan and mechanical wall fans are also appliances often operated by pull switches. . Pull switches may be either two-position (open or closed) or multi-position (allowing for different fan speeds or levels of illuminati
Video demonstrating the operation of a touch-sensitive lamp. A touch-sensitive lamp is a combination of a lamp and a touch switch. They act on the principle of body capacitance, activated by human touch rather than a flip, push-button, or other mechanical switch. They are popular as desk and nightstand lamps. Touch-sensitive lamp switches may ...
Portable lamps such as table lamps may have a light switch mounted on the socket, base, or in-line with the cord. Manually operated on/off switches may be substituted by dimmer switches that allow controlling the brightness of lamps as well as turning them on or off, time-controlled switches, occupancy-sensing switches, and remotely controlled ...
The latter use a standard light switch, and the on-board electronics chooses the light output level based on the number of times the switch is turned on and off quickly. Dimmable CFLs are not a 100% replacement for incandescent fixtures that are dimmed for "mood scenes" such as wall sconces in a dining area.
A preheat fluorescent lamp "starter" (automatic starting switch) Before the 1960s, four-pin thermal starters and manual switches were used. [citation needed] A glow switch starter automatically preheats the lamp cathodes. It consists of a normally open bi-metallic switch in a small sealed gas-discharge lamp containing inert gas (neon or argon ...
For dimmable fluorescent lamps (where it operates instead at 1-10 V, where 1 V is minimum and 0 V is off) the system is being replaced by DSI, which itself is in the process of being replaced by DALI. Examples for digital lighting control systems are: DALI based system. DSI based system; KNX based systems; Those are all wired lighting control ...
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
The timer may switch equipment on, off, or both, at a preset time or times, after a preset interval, or cyclically. A countdown time switch switches power, usually off, after a preset time. A cyclical timer switches equipment both on and off at preset times over a period, then repeats the cycle; the period is usually 24 hours or 7 days.