Search results
Results from the WOW.Com Content Network
In 1983, Molex introduced the 8981 connector under the trademark Disk Drive Power Connection System, [5] which was fully compatible with the AMP Mate-n-Lok connector. [6] The Molex 8981 series was only produced in a 4-position option, unlike the Mate-n-Lok family which includes many other contact arrangements.
The 8P8C jack used by structured cabling physically accepts the 6-position connector that fits RJ11, RJ14 and RJ25. Only lines 1 and 2 have electrical compatibility, with T568A wiring, and only line 1 with T568B wiring, because Ethernet-compatible pin assignments split the third pair of RJ25 across two separate cable pairs, rendering that pair ...
For example, RJ11 and RJ14 use female six-position modular connectors, and RJ21 uses a 25-pair (50-pin) miniature ribbon connector. RJ11 uses two conductors in a six-position female modular connector, so can be made with any female six-position modular connector, while RJ14 uses four, so can be made with either a 6P4C or a 6P6C connector.
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
Molex acquired Woodhead Industries in 2006; [8] the largest acquisition in the former's history at the time. On February 14, 2005, Molex announced its results for the six months ended December 31, 2004, that reflect certain adjustments to its results of operations for the first fiscal quarter ended September 30, 2004. [ 9 ]
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
Molex connectors were frequently used as DC power connectors in personal computers, for floppy, hard disk, and CD drives. These connectors have four pins, +5 V (red), 2 common ground (black), and +12 V (yellow). SATA peripherals use a different style of connector. Locking Molex connectors are available in 3, 4, and 6 terminal configurations.