Search results
Results from the WOW.Com Content Network
There are many variations in the design of quick couplers. The initial divergence is between those that can pick up any of a range of buckets and attachments by clamping onto the mounting pins for the attachment (known as "pin grabbers" or "pin couplers") and those that work only with buckets and attachments designed to suit that quick coupler (known as "dedicated").
Excavator controls specifies ways of how a human operator controls the digging components (i.e. swing, boom, stick, bucket) of a piece of heavy machinery, ...
There are also many other attachments that are available to be attached to the excavator for boring, ripping, crushing, cutting, lifting, etc. Attachments can be attached with pins similar to other parts of the arm or with some variety of quick coupler. Excavators in Scandinavia often feature a tiltrotator which allows attachments rotate 360 ...
Fitting profiles have identifiable geometry on the male end, but care must be taken to use a compatible coupler. Couplers use springs and balls to lock mating nipples into place. A seal is effected using O-rings along the shaft of the nipple or by compression by the tip.
For hoses and piping, a quick connect fitting, also called a push fitting or Quick Connect Coupling, is a coupling used to provide a fast, make-or-break connection of gas or liquid transfer lines.
A PTO at the rear end of a farm tractor A PTO (in the box at the bottom) in the center of the three-point hitch of a tractor. A power take-off or power takeoff (PTO) is one of several methods for taking power from a power source, such as a running engine, and transmitting it to an application such as an attached implement or separate machine.
Bell-and-hook couplers began to be replaced on the Avontuur Railway upon the introduction of Class 91-000 diesel-electric locomotives on the narrow gauge system in 1973. All new narrow gauge rolling stock acquired for that line from that year were equipped with Willison couplers. Older rolling stock were not converted and an adapter was used to ...
Mechanical couplers can be advantageous in comparison with conventional methods of lap splicing because of the requirement for less steel for overlapping. It is more effective in the seismic detailing to avoid reinforcement congestion problems. [3] The couplers are also used in pre-cast construction. [4]