Search results
Results from the WOW.Com Content Network
A wildcard mask is a mask of bits that indicates which parts of an IP address are available for examination. In the Cisco IOS, [1] they are used in several places, for example: To indicate the size of a network or subnet for some routing protocols, such as OSPF. To indicate what IP addresses should be permitted or denied in access control lists ...
A subnet mask is a bitmask that encodes the prefix length associated with an IPv4 address or network in quad-dotted notation: 32 bits, starting with a number of 1-bits equal to the prefix length, ending with 0-bits, and encoded in four-part dotted-decimal format: 255.255.255.0. A subnet mask encodes the same information as a prefix length but ...
Subnet mask: 4 octets: Client's subnet mask as per RFC 950. If both the subnet mask and the router option (option 3) are included, the subnet mask option must be first. 2: Time offset: 4 octets: Offset of the client's subnet in seconds from Coordinated Universal Time (UTC). The offset is expressed as a two's complement 32-bit integer.
An IPv4 subnet mask consists of 32 bits; it is a sequence of ones (1) followed by a block of zeros (0). The ones indicate bits in the address used for the network prefix and the trailing block of zeros designates that part as being the host identifier.
At run time, to put the image on the screen over the background, the program first masks the screen pixel's bits with the image mask at the desired coordinates using the bitwise AND operation. This preserves the background pixels of the transparent areas while resets with zeros the bits of the pixels which will be obscured by the overlapped image.
Today, IP addresses are associated with a subnet mask. This was not required in a classful network because the mask was implied by the address itself; any network device would inspect the first few bits of the IP address to determine the class of the address and thus its netmask.
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
As shown in the example below, in order to calculate the directed broadcast address to transmit a packet to an entire IPv4 subnet using the private IP address space 172.16.0.0 / 12, which has the subnet mask 255.240.0.0, the broadcast address is calculated as 172.16.0.0 bitwise ORed with 0.15.255.255 = 172.31.255.255. Directed broadcasts always ...