Search results
Results from the WOW.Com Content Network
In ISA temperature conditions the altimeter will read the height above the airfield/runway in the vicinity of the airfield. SPS/STD - 'Standard Pressure Setting' or just 'Standard' refers to the altimeter being set to the standard pressure of 1013.25 hPa. It is the setting that causes an altimeter to read the aircraft's flight level (FL).
12 November 1996, an Il-76 collided in mid air with a Saudi B747 near New Delhi India, following a level bust by the Il-76.; 12 November 1996, a B737 descended below its assigned holding level in the LHR stack, in IMC, to within 100 feet vertically and between 680 and 820 metres horizontally of an MD-81 at its correct level.
The altimeter, which is usually a barometer calibrated in units of distance instead of atmospheric pressure, can therefore be set in such a way as to indicate the height of the aircraft above ground. This is done by communicating with the control tower of the airport (to get the current surface pressure) and setting the altimeter so as to read ...
In a mode C reply, the altitude is encoded by a Gillham interface, Gillham code, which uses Gray code. The Gillham interface is capable of representing a wide range of altitudes, in 100-foot (30 m) increments. The altitude transmitted is pressure altitude, and corrected for altimeter setting at the ATC facility. If no encoder is attached, the ...
The altimeter setting used is the ISA surface pressure of 1013 hPa or (29.92 inHg). The actual surface pressure may vary from this at different locations and times. Therefore, by using a standard pressure setting, every aircraft has the same altimeter setting, and vertical clearance can be maintained. [1] Scale comparison of some flight level ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Help; Learn to edit; Community portal; Recent changes; Upload file
High angle of attack protection may be lost and low energy (level flight stall) protection is lost. High speed and high angle of attack protections enter alternate law mode. [8] ALT1 may be entered if there are faults in the horizontal stabilizer, an elevator, yaw-damper actuation, slat or flap sensor, or a single air data reference fault. [7]
Leveling off at 2,000 feet (610 m), the airliner experienced heavy turbulence near Santo Espírito and subsequently impacted the ridge of Pico Alto in a level attitude at an altitude of 1,795 feet (547 m). There was no evidence of any in-flight emergency and the altimeter was found correctly set to 1027 mb.