enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Piling - Wikipedia

    en.wikipedia.org/wiki/Piling

    Also called caissons, drilled shafts, drilled piers, cast-in-drilled-hole piles (CIDH piles) or cast-in-situ piles, a borehole is drilled into the ground, then concrete (and often some sort of reinforcing) is placed into the borehole to form the pile. Rotary boring techniques allow larger diameter piles than any other piling method and permit ...

  3. Angle of repose - Wikipedia

    en.wikipedia.org/wiki/Angle_of_repose

    Angle of repose of a heap of sand Sandpile from the Matemateca collection. The angle of repose, or critical angle of repose, [1] of a granular material is the steepest angle of descent or dip relative to the horizontal plane on which the material can be piled without slumping.

  4. Soil compaction - Wikipedia

    en.wikipedia.org/wiki/Soil_compaction

    In geotechnical engineering, soil compaction is the process in which stress applied to a soil causes densification as air is displaced from the pores between the soil grains. When stress is applied that causes densification due to water (or other liquid) being displaced from between the soil grains, then consolidation, not compaction, has occurred.

  5. Base course - Wikipedia

    en.wikipedia.org/wiki/Base_course

    F. Fine-grained sand. The base course or basecourse in pavements is a layer of material in an asphalt roadway, race track, riding arena, or sporting field. It is located under the surface layer consisting of the wearing course and sometimes an extra binder course. If there is a sub-base course, the base course is constructed directly above this ...

  6. Dilatancy (granular material) - Wikipedia

    en.wikipedia.org/wiki/Dilatancy_(granular_material)

    Dilatancy of a sample of dense sand in simple shear. The phenomenon of dilatancy can be observed in a drained simple shear test on a sample of dense sand. In the initial stage of deformation, the volumetric strain decreases as the shear strain increases. But as the stress approaches its peak value, the volumetric strain starts to increase.

  7. Retaining wall - Wikipedia

    en.wikipedia.org/wiki/Retaining_wall

    Bored pile retaining wall in Lisbon, Portugal. Bored pile retaining walls are built by assembling a sequence of bored piles, followed by excavating away the excess soil. Depending on the project, the bored pile retaining wall may include a series of earth anchors, reinforcing beams, soil improvement operations and shotcrete reinforcement layer.

  8. Unified Soil Classification System - Wikipedia

    en.wikipedia.org/wiki/Unified_Soil...

    sand ≥ 50% of coarse fraction passes No.4 (4.75 mm) sieve clean sand SW well-graded sand, fine to coarse sand SP poorly graded sand sand with >12% fines SM silty sand SC clayey sand Fine grained soils 50% or more passing the No.200 (0.075 mm) sieve silt and clay liquid limit < 50 inorganic: ML silt CL lean clay organic: OL organic silt ...

  9. Wave equation analysis - Wikipedia

    en.wikipedia.org/wiki/Wave_equation_analysis

    The soil response for each pile segment is modeled as viscoelastic-plastic. The method was first developed in the 1950s by E.A. Smith of the Raymond Pile Driving Company. Wave equation analysis of piles has seen many improvements since the 1950s such as including a thermodynamic diesel hammer model and residual stress. Commercial software ...