enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Serial Peripheral Interface - Wikipedia

    en.wikipedia.org/wiki/Serial_Peripheral_Interface

    Quad SPI (QSPI; different to but has same abbreviation as Queued-SPI described in § Intelligent SPI controllers) goes beyond dual SPI, adding two more I/O lines (SIO2 and SIO3) and sends 4 data bits per clock cycle. Again, it is requested by special commands, which enable quad mode after the command itself is sent in single mode.

  3. OpenCores - Wikipedia

    en.wikipedia.org/wiki/OpenCores

    The cores are implemented in the hardware description languages Verilog, VHDL or SystemC, which may be synthesized to either silicon or gate arrays. The project aims at using a common non-proprietary system bus named Wishbone, and most components are nowadays adapted to this bus. Among the components created by OpenCores contributors are:

  4. Wishbone (computer bus) - Wikipedia

    en.wikipedia.org/wiki/Wishbone_(computer_bus)

    This ambiguity is intentional. Wishbone is made to let designers combine several designs written in Verilog, VHDL or some other logic-description language for electronic design automation (EDA). Wishbone provides a standard way for designers to combine these hardware logic designs (called "cores"). Wishbone is defined to have 8, 16, 32, and 64 ...

  5. AVR microcontrollers - Wikipedia

    en.wikipedia.org/wiki/AVR_microcontrollers

    The in-system programming (ISP) programming method is functionally performed through SPI, plus some twiddling of the Reset line. As long as the SPI pins of the AVR are not connected to anything disruptive, the AVR chip can stay soldered on a PCB while reprogramming. All that is needed is a 6-pin connector and programming adapter.

  6. Chip select - Wikipedia

    en.wikipedia.org/wiki/Chip_select

    An example SPI with a master and three slave select lines. Note that all four chips share the SCLK, MISO, and MOSI lines but each slave has its own slave select. Chip select (CS) or slave select (SS) is the name of a control line in digital electronics used to select one (or a set) of integrated circuits (commonly called "chips") out of several connected to the same computer bus, usually ...

  7. OpenSPARC - Wikipedia

    en.wikipedia.org/wiki/OpenSPARC

    OpenSPARC is an open-source hardware project, started in December 2005, for CPUs implementing the SPARC instruction architecture. The initial contribution to the project was Sun Microsystems' register-transfer level (RTL) Verilog code for a full 64-bit, 32-thread microprocessor, the UltraSPARC T1 processor.

  8. Verilog - Wikipedia

    en.wikipedia.org/wiki/Verilog

    Verilog-2001 is a significant upgrade from Verilog-95. First, it adds explicit support for (2's complement) signed nets and variables. Previously, code authors had to perform signed operations using awkward bit-level manipulations (for example, the carry-out bit of a simple 8-bit addition required an explicit description of the Boolean algebra ...

  9. Icarus Verilog - Wikipedia

    en.wikipedia.org/wiki/Icarus_Verilog

    Released under the GNU General Public License, Icarus Verilog is free software, an alternative to proprietary software like Cadence's Verilog-XL. As of release 0.9, Icarus is composed of a Verilog compiler (including a Verilog preprocessor) with support for plug-in backends, and a virtual machine that simulates the design.