enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Ford Mustang variants - Wikipedia

   en.wikipedia.org/wiki/Ford_Mustang_variants

   The rear control arm pivot points were lowered 1/2-inch on the upper end and 1/4-inch on the lower end for improved suspension geometry. In addition, quad shocks replaced the old-style traction bars and the rear anti-roll bar diameter increased to 0.79 inches (20 mm) compared to 0.67 inches (17 mm) in 1983.

3. Ford 8.8 axle - Wikipedia

   en.wikipedia.org/wiki/Ford_8.8_axle

   Ring, pinion and carrier all remained between the solid axle and independent rear suspension. The solid rear axle from 1995-2001 Explorers is a popular swap for older Jeep Wranglers and Cherokees. In addition to being nearly the same width, they have the same wheel bolt pattern, are equipped with disc brakes, and are much stronger than the Dana ...

4. Shelby Mustang - Wikipedia

   en.wikipedia.org/wiki/Shelby_Mustang

   The rear end was replaced with a high performance 9-inch unit; the brakes included 6 pistons in front and 4 pistons out back. The driveshaft was a stronger unit while the suspension included new struts, sway bars and bushings. The hood, rear panel and splitter were functional pieces for performance.

5. Ford Mustang - Wikipedia

   en.wikipedia.org/wiki/Ford_Mustang

   A 1971 Mustang (modified to look like a 1973 model), nicknamed "Eleanor", was the feature car in the 1974 car heist film Gone in 60 Seconds. "Eleanor" returned, as a 1967 Mustang Shelby GT500, in the movie's remake in 2000. The remake version of Eleanor featured a custom body kit designed by Chip Foose that has inspired numerous restomods since.

6. Ford Mustang (first generation) - Wikipedia

   en.wikipedia.org/wiki/Ford_Mustang_(first...

   When equipped with the 289 "HiPo" engine and a 4.11 rear axle ratio, the 1965 Mustang achieved 0–60 mph (0–97 km/h) in 5.2 seconds and a 1 ⁄ 4 mile (402 m) time of 14.0 seconds at 100 mph (161 km/h). [34] The 1966 Mustang debuted with moderate trim changes including a new grille, side ornamentation, wheel covers, and gas cap.

7. Twist-beam rear suspension - Wikipedia

   en.wikipedia.org/wiki/Twist-beam_rear_suspension

   The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.