Search results
Results from the WOW.Com Content Network
Semi-automatic transmissions were almost exclusively used in motorcycles and are based on conventional manual transmissions or sequential manual transmissions, but use an automatic clutch system. But some semi-automatic transmissions have also been based on standard hydraulic automatic transmissions with torque converters and planetary gearsets ...
They are much less common than motorcycles with conventional manual transmissions, typically use a centrifugal clutch, and are mostly found on smaller motorcycles, such as minibikes, underbone (step-thru) motorcycles (e.g., the Honda Super Cub), smaller dirt bikes (such as pit bikes), and various (mostly older) mopeds and motor scooters. Semi ...
Slipping the clutch (sometimes referred to as feathering the clutch) is a term used by automotive enthusiasts to describe when the driver alternately applies and releases the clutch to achieve some movement of the car. It's called slipping because the clutch plate will slip against the flywheel surface when such an action is performed. Slipping ...
The term scooty has become the generic term for scooter in India [1]. A scooter (motor scooter) is a motorcycle with an underbone or step-through frame, a seat, a transmission that shifts without the operator having to operate a clutch lever, a platform for their feet, and with a method of operation that emphasizes comfort and fuel economy.
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
Some motor scooters include a centrifugal clutch, to assist when idling or manually reversing the scooter. [48] The 1974 Rokon RT340 TCR Automatic off-road motorcycle was fitted with a snowmobile CVT. The first ATV equipped with a CVT was the Polaris Trail Boss in 1985. [citation needed]
A chainsaw's clutch. The chain wraps around a sprocket behind the clutch that turns with the outer drum. The input of the clutch is connected to the engine crankshaft while the output may drive a shaft, chain, or belt. As engine revolutions per minute increase, weighted arms in the clutch swing outward and force the clutch to engage. The most ...
Before the introduction of transmission synchronizers in 1927, [2] double clutching was a technique required to prevent damage to an automobile's gearing during shifts. Due to the difficulty and most often unnecessary redundancy involved in the technique, coupled with the advent of synchronized gearing systems, it has largely fallen into disuse in light vehicles.