enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Four-terminal sensing - Wikipedia

   en.wikipedia.org/wiki/Four-terminal_sensing

   Four-point measurement of resistance between voltage sense connections 2 and 3. Current is supplied via force connections 1 and 4. In electrical engineering, four-terminal sensing (4T sensing), 4-wire sensing, or 4-point probes method is an electrical impedance measuring technique that uses separate pairs of current-carrying and voltage-sensing electrodes to make more accurate measurements ...

3. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   PLASTI-GRIP (Vinyl) (insulation restricting) terminals are defined in AMP Specification 114-1003: Terminal, FASTON, PLASTI-GRIP, Application of; UL 310 "Standard for Electrical Quick-Connect Terminals" [4] CSA 22.2 #153, "Quick-Connect Terminals" UL 486 also specifies the testing of standard wire connectors and soldering lugs. MIL-T-7928

4. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [2] [3] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers, battery eliminator circuits, 3D printers, and radio controlled servos. [4]

5. Sense (electronics) - Wikipedia

   en.wikipedia.org/wiki/Sense_(electronics)

   In electronics, sense is a technique used in power supplies to produce the correct voltage for a load.Although simple batteries naturally maintain a steady voltage (except in cases of large internal impedance), a power supply must use a feedback system to make adjustments based on the difference between its intended output and its actual output.

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   [7]: 40 By definition, each end of this "adapter" has a different connection method – e.g. the solder tabs on a male phone connector, and the male phone connector itself. [3] In this example, the solder tabs connected to the cable represent the permanent connection, whilst the male connector portion interfaces with a female socket forming a ...

7. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as IEC 61169-54; Belling-Lee connector, also called IEC 61169-2 connector, used throughout Europe and Australia, as well as parts of South-East Asia, for domestic television and FM radio antenna cabling