Search results
Results from the WOW.Com Content Network
Modern aircraft wings may have different airfoil sections along the wing span, each one optimized for the conditions in each section of the wing. Movable high-lift devices, flaps and sometimes slats, are fitted to airfoils on almost every aircraft. A trailing edge flap acts similarly to an aileron; however, it, as opposed to an aileron, can be ...
Aircraft wing showing the KFm2 Step Aircraft wing showing the KFm3 Step. The Kline–Fogleman airfoil or KF airfoil is a simple airfoil design with single or multiple steps along the length of the wing. The purpose of the step, it is claimed, is to allow some of the displaced air to fall into a pocket behind the step and become part of the ...
The Davis wing is a World War II-era aircraft wing design that was used by Consolidated Aircraft on the Consolidated B-24 Liberator, as well as other models. The airfoil had a lower drag coefficient than most contemporary designs, which allowed higher speeds, and created significant lift at relatively low angles of attack.
For example, the NACA 2412 airfoil has a maximum camber of 2% located 40% (0.4 chords) from the leading edge with a maximum thickness of 12% of the chord. The NACA 0015 airfoil is symmetrical, the 00 indicating that it has no camber. The 15 indicates that the airfoil has a 15% thickness to chord length ratio: it is 15% as thick as it is long.
A tandem wing design has two wings, one behind the other: see Tailplanes and foreplanes below. Some early types had tandem stacks of multiple planes, such as the nine-wing Caproni Ca.60 flying boat with three triplane stacks in tandem. A cruciform wing is a set of four individual wings arranged in the shape of a cross. The cross may take either ...
Aerodynamicists determined that, by appropriately shaping the airfoil used, the severity of these problems could be greatly reduced, allowing the aircraft to attain much higher speeds; this is the basis of the supercritical wing. Its design allows the wing to maintain high performance levels at speeds closer to Mach 1 than traditional counterparts.
Washout is a characteristic of aircraft wing design which deliberately reduces the lift distribution across the span of an aircraft’s wing. The wing is designed so that the angle of incidence is greater at the wing roots and decreases across the span, becoming lowest at the wing tip.
An aircraft with wings using a cambered airfoil will have a lower stalling speed than an aircraft with a similar wing loading and wings using a symmetric airfoil. One recent cambered design is called the supercritical airfoil. It is used for near-supersonic flight and produces a higher lift-to-drag ratio at near supersonic flight than ...